|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-03-2016, 07:51 PM
|
#1 |
|
Registered User
Join Date: Jul 2015
Location: Norco, LA
Posts: 9
|
Squarebody electrical issues
Ran into a problem yesterday and any advance would help! Was putting my carb back in yesterday after a rebuild so I took my battery out to put it on the charger because it's been sitting for a few weeks. When I put it back in I put the terminals back on but like an ass didn't tighten them up
 . Anyway, when I went to fire up my truck I heard an electrical pop and some smoke near the battery. Now I'm not getting any power to the ignition and I have no power to headlights or acc. I figure it either one of my fusible links or my ignition switch but I gave all the links a good tug and they feel strong still. I even changed the link at the junction next to the brake booster. Any help would be much appreciated! Thanks fellas 
|
|
|
|
12-03-2016, 07:55 PM
|
#2 |
|
Registered User
Join Date: Jul 2015
Location: Norco, LA
Posts: 9
|
Re: Squarebody electrical issues
Forgot to mention its a 1984 c10
|
|
|
|
|
12-03-2016, 11:44 PM
|
#3 |
|
Registered User
Join Date: May 2011
Location: Goliad, TX
Posts: 672
|
Re: Squarebody electrical issues
Start with the basics and clean your terminals.
__________________
1990 ¾ ton 4x4 Chevy Suburban -Cummins Diesel - 12 valve - factory rebuilt -6 speed bullet proof manual transmission - NV5600 -Gear Vendors Overdrive - HX35 Holset Turbo -NP205 iron transfer case -3.73 gears -2" Lift |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
