![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Dec 2014
Location: greenville
Posts: 53
|
Air ride frame question?
I don't know if this is the proper place for this question but I have a 1965 c10 short box. My question is if am going to run air ride and am going too cnotch the frame. Is a small cnotch the way to go with air bags on the trailing arms. Or go with a cnotch with a bridge and bags over axle? I am looking to run a motor with around 400 to 500 hp and am somewhat worried about stregth. What do you guys recommend?
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Oct 2016
Location: san bernardino ca
Posts: 1,611
|
Re: Air ride frame question?
It all about how low you want too go. Lay frame or about a 5 or 7 inch drop? I just did mine cnotch and i will going 7 inch drop .
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2014
Location: greenville
Posts: 53
|
Re: Air ride frame question?
My main concern is stregth of the frame? I am not to concerned about laying frame per say.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2016
Location: san bernardino ca
Posts: 1,611
|
Re: Air ride frame question?
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Oct 2016
Location: san bernardino ca
Posts: 1,611
|
Re: Air ride frame question?
With mine the company said the cnotch is heavy duty. If your going too do burnouts and have a 600 hp motor then you should weld it.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|