Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-26-2017, 10:54 PM | #3 |
Senior Member
Join Date: Jul 2012
Location: St. John, Washington
Posts: 617
|
Re: 1972 C30 Dually Eaton Rear brake backing plates
Sorry, my drums were junk. The brake hardware had fallen out and put a 1/2" deep groove in the drums.
I swapped the entire brake setup from a early 80s square body 1 ton dually onto my 72. Any GM 14 bolt dually can be used as a donor. use all the brake parts from the square body, and the bearing carriers/spindles and axle shafts from your 72. I recomend the swap, parts are much easier to find!!
__________________
"Rusty" 1972 K20 Cheyenne Super, 496, A/C, Tilt, Tach, Buckets, 4l80e/NP205, 4" Rancho Lift, 35" BFG AT "Ramp Truck" 1972 C30 Ramp Truck 350, Air Bags, Factory A/C. "1968" C10 Shortbed project |
Bookmarks |
|
|