|
09-18-2017, 01:07 PM
|
#1 |
|
Registered User
Join Date: Sep 2017
Location: Sulphur, Louisiana
Posts: 42
|
Rear End Clearance
What is the minimum clearance you can have between the frame and top of rear end on a 68 C10? I have about 3" now and want to lower it another 1-1/2". Do I need to go ahead and do a C notch kit?
|
|
|
|
09-18-2017, 01:30 PM
|
#2 |
|
Senior Member
 
Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,051
|
Re: Rear End Clearance
I'd say yes, because if you haul anything with any weight you'll be out of travel and be bottoming out .
|
|
|
|
|
09-19-2017, 10:18 PM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,715
|
Re: Rear End Clearance
I flipped the leaf spring rear in my 69 and it dropped it just over 7". I have about 1 1/2" between axle housing and frame. I put the 3/8" thick urethane "pad" on the frame above the housing and I removed the factory bump stop steel pads on the housing.
I have no problem loading several hundred pounds in the bed, but it does hit the bump stops on big bumps.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
|
09-20-2017, 08:44 AM
|
#4 |
|
Registered User
Join Date: Sep 2017
Location: Sulphur, Louisiana
Posts: 42
|
Re: Rear End Clearance
Thanks for information. I'm gonna have about the same amount of clearance. Where did you get the pads for the frame?
|
|
|
|
|
09-20-2017, 09:15 PM
|
#5 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,715
|
Re: Rear End Clearance
They came with the DJM kit. They are a urethane puck with a 1/4" stud on the back.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
