Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-12-2018, 11:55 PM | #7 |
Registered User
Join Date: Oct 2017
Location: Calgary, Alberta
Posts: 208
|
Re: 66 GMC Long to Short LS Swap
More sheet metal work the last few days. Finished patching in in the floor support[IMG]IMG_3657 by Duncan Keith, on Flickr[/IMG]
[IMG]IMG_3659 by Duncan Keith, on Flickr[/IMG] [IMG]IMG_3662 by Duncan Keith, on Flickr[/IMG] Next up was the rear cab support. The first one I ordered was way too big, no way to make it work. Tried a different supplier off eBay. Not much better, about an inch too long and the angle where it meets the floor pan wasn't even close. Are all these reproduction pieces garbage or is there somewhere better to order from? [IMG]IMG_3669 by Duncan Keith, on Flickr[/IMG] [IMG]IMG_3668 by Duncan Keith, on Flickr[/IMG] [IMG]IMG_3670 by Duncan Keith, on Flickr[/IMG] Had to chop and weld this thing back together. Would almost be quicker to make one from scratch. [IMG]IMG_3671 by Duncan Keith, on Flickr[/IMG] Eventually got it fitted and welded in. With that done i started on the front part of the floor pan [IMG]IMG_3664 by Duncan Keith, on Flickr[/IMG] [IMG]IMG_3663 by Duncan Keith, on Flickr[/IMG] |
Bookmarks |
|
|