Quote:
Originally Posted by ray_mcavoy
The ends of the flex lines have both external & internal threads.
The external threads are used with a thin jamb nut to secure the flex lines to the frame.
The internal threads should accept the inverted flare nuts on the hard lines. And there should be a cone shaped seat at the bottom of the inner hole that seals against the flared end of the hard line. The factory hard lines usually had a fairly sharp bend close to the end instead of using a separate elbow fitting.
|
Right after I posted this I noticed the flex line was threaded! Guess I should have looked first. . I have a bunch of spare 1/4” line and the fitting off the flex is 3/16 so I’m gonna try and find an elbow or adapter to run my 1/4”. This should take care of the problem. Now just need to find a jam nut. Our chassis didn’t have any lines so I’ll be making a trip to the store again.
05-10-2018, 05:03 PM
Threaded Mode