Lowered front end questions

[Cristiann8]

Hello, everybody I have 2 inch lowering springs and 2 1/2 inch drop spindles but my front end doesn’t look anywhere near 4 1/2 drop, there’s no engine and tranny or my inner fenders yet and I highly doubt a engine and tranny will drop it to make it look right. I’ll attach pictures, I want opinions on what you guys think. I might get a different springs cause I don’t like the way it sits right now
Posted via Mobile Device

[Boog]

Wait 'till you get everything in and on the truck before making any more spring changes. The springs will compress further with the added weight.

[shoveldug]

Its going to sit where you want it to. Maybe even lower than you want. i have the same setup.

[elf w/capital T]

Wait until you get motor and transmission in mate, it will drop...

[saxart]

Not only will it drop after you put the engine in it, but it will also drop a bit more once you start driving it and things settle in.

[cornerstone]

I agree as well, get the weight on and you'll see! I'm guessing those are 15" rims too so it does make it appear to sit a bit high at the moment.
Brian

[Redneck Rydes]

X2

[Cristiann8]

Originally Posted by Boog

Wait 'till you get everything in and on the truck before making any more spring changes. The springs will compress further with the added weight.

Ok, thanks for the reply, I hope so
Posted via Mobile Device

[Cristiann8]

Originally Posted by shoveldug

Its going to sit where you want it to. Maybe even lower than you want. i have the same setup.

Ok cool, I was starting to panic a bit lol, thanks for the reply
Posted via Mobile Device