![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#4 |
Senior Member
![]() Join Date: Jul 2000
Location: North Texas
Posts: 3,465
|
Re: Proportioning valve vs No valve
For manual brakes the factory used a master cylinder bore of just under 1 inch (25 mm, I think). At least that was true for the 82 model C10.
If I were going power to manual, I'd probably do 15/16". And if you plumb in a manual prop valve, you can fine tune the system so the rears don't lock up prematurely. BTW, for me this would be the ultimate kit. I had the 7/8" version on a 55 Chevy car with entry-level Wilwood front brakes and 9"x 2" rear drums. Worked great! Move down the page to see the 15/16" and 7/8" part numbers.https://www.wilwood.com/MasterCylind...%20and%20Valve ![]()
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! Last edited by MikeB; 04-20-2020 at 01:24 AM. |
![]() |
![]() |
Bookmarks |
|
|