Tahoe Floor Access Plate?

[Ironhorse]

Originally Posted by S10Fan

Drilled a hole in each corner, stuffed a welding blanket over top the tank, yes, total PIA. Used a saber saw after cutting off a little of the blade. If I remember correctly there was a couple inches or more between the tank and the floor. Again if I remember correctly the hole was roughly 10" square.

Bryan, thanks for the reply and the tips. Sounds like a future project I need to look into for sure. Has to be a much easier method than having to drop the tank to change the pump. Just really sad that GM design engineers and bean counters couldn't think to do this on all Tahoes and Suburbans going down the assembly line. If done decently with a good fit would work fine also on pickup beds.