Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
08-01-2021, 06:15 PM | #1 |
Registered User
Join Date: Jun 2012
Location: wind lake WI
Posts: 1,747
|
Re: Same quadrajet instead of double pumper holley???
This much I can say, the Q-jet will be a pita to properly jet to your new engine. You almost need a master’s degree. I pulled my Q-jet off and put my old 4150 on with a 1” spacer what difference, I also put an electric choke kit on it and new jets and power valves , so easy to tune. So this is just my 2cents, good luck!
__________________
LIL ERV the 50-3600 396 BBC stroked to 415 cid Richmond 6spd over drive C4 rear Porter built a arms Never give the Devil a ride,because he'll want to Drive! |
08-01-2021, 06:37 PM | #2 |
Senior Member
Join Date: Dec 2009
Location: TN.
Posts: 7,838
|
Re: Same quadrajet instead of double pumper holley???
I would give that Quadrajet a try.
You will only be out the cost of a spacer an gaskets. Make sure both spacer gaskets cover ( fully ). The intake to spacer gasket and the carb to spacer gasket should have 100% coverage with no gaps or you will have a vaccum leak. Then if Quadrajet doesn't run good,Try the Holley it may run okay? JMHO .....
__________________
________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build |
08-01-2021, 11:01 PM | #3 | |
Registered User
Join Date: Feb 2014
Location: marietta ga
Posts: 147
|
Re: Same quadrajet instead of double pumper holley???
Quote:
__________________
: Eli540 86 gmc 2500 longbed Carb 5.7, rwd, 400 tranny. |
|
08-02-2021, 12:28 AM | #4 |
Registered User
Join Date: Feb 2014
Location: marietta ga
Posts: 147
|
Re: Same quadrajet instead of double pumper holley???
From what I found the adapter for the quadrajet is from Mr gasket....Is this the right part number 1932?? If I go with Holley I can grab same day from summit here in ga....but they have their own part number from others retailers.....I'm wanted to grab both for the time being..... other than AutoZone where is am the best place to get original parts for 70s block, I need a dipstick, and few other grabs.
__________________
: Eli540 86 gmc 2500 longbed Carb 5.7, rwd, 400 tranny. |
Bookmarks |
|
|