A '62 has to get back on the road - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Braunschweiger · 01-14-2022, 11:37 AM

New sheet metal must be installed inside and outside above
the windscreen and on the passenger side above the door.
Recreating the inner post corner was very complicated,
I don't want to do it again

Braunschweiger · 01-14-2022, 01:01 PM

The outer panel fitted, unfortunately it is
almost 1/2" too short, so adjust it.
A little Bondo is necessary.
That looks better.

01-14-2022, 11:37 AM	#1
Braunschweiger Registered User Join Date: Aug 2020 Location: Braunschweig, Lower Saxony, Germany Posts: 763	Re: A '62 has to get back on the road New sheet metal must be installed inside and outside above the windscreen and on the passenger side above the door. Recreating the inner post corner was very complicated, I don't want to do it again Attached Images

01-14-2022, 01:01 PM	#2
Braunschweiger Registered User Join Date: Aug 2020 Location: Braunschweig, Lower Saxony, Germany Posts: 763	Re: A '62 has to get back on the road The outer panel fitted, unfortunately it is almost 1/2" too short, so adjust it. A little Bondo is necessary. That looks better. Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.