|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-08-2022, 12:02 AM
|
#1 |
|
Revitalizing a 6T C10
 
Join Date: Aug 2017
Location: Santa Barbara, CA
Posts: 222
|
Locking Lug Nuts - Master Key Set
Hey All,
My car was broken into about a year ago, and in addition to all of the other stuff I keep wishing I had, I just realized I don't have my lug nut / wheel key any more either. They have external splines, and it looks like there are a few kits that may have them covered, but is there a preferred brand or manufacturer ? I don't plan on using them more then once, but I need to get all 4 off of a pretty tight wheel.
__________________
1960 C-10 Apache- "Rusty the Redneck Reject"
1/2 Ton short bed step side. 350 crate motor, 3 speed manual (floor shifted) MKII - Buddy Buckets and Glass Packs 20+ year long term project in process Lots of Rust, more memories... |
|
|
|
05-11-2022, 02:16 PM
|
#2 |
|
Senior Member
Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,100
|
Re: Locking Lug Nuts - Master Key Set
Those kits are all pretty much the same, just a different brand slapped on the box. I got one to help a buddy out who lost his key. His was some odd ball spline count and after a little digging I found they were from the wheel manufacture, looked it up and had one overnighted. Never ended up using the kit.
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
|
|
|
| Bookmarks |
| Tags |
| lug nuts, tools |
|
|
Linear Mode
