Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-28-2022, 09:24 PM | #38 | |
Registered User
Join Date: Feb 2011
Location: Under the Truck Dreaming
Posts: 712
|
Re: Another NV4500 to NP205
Quote:
I kept the transfer case shifters in the same location as stock due to the bench seat. But I did have to move my engine forward for this. My trans cross member is stock, in the stock location. I only needed to make a pedestal type adapter for my NV tail housing to bolt to and that bolts on to the stock rubber trans mount. I did not lower the transfer case, it sits about 1/2" below the cab floor. (it might be slightly higher by 1/4" or so, maybe). My front and rear driveshaft angles should be really close to stock. I will need to measure for length to make sure as I have a D60 in front now (should be a shorter driveshaft) Clutch master cyl and slave cyl install are next....Here are a couple more of the linkage I milled up.
__________________
72 K20 Custom Camper, D60, 14BFF, full roller 406 TPI w custom built ECU and yes..it has tow hooks... |
|
Bookmarks |
|
|