|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-06-2015, 06:28 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: St Robert, Mo
Posts: 730
|
WTB High Idle Switch
WTB High Idle or PTO Switch for a 99-07. I need the switch, bezel and at least some of the wiring... Shipped to 65584.
This is located just to the right of the HVAC controls if the truck has it... Thanks! |
|
|
|
12-21-2015, 01:24 AM
|
#2 |
|
Registered User
Join Date: Jun 2011
Location: St Robert, Mo
Posts: 730
|
Re: WTB High Idle Switch
ttt...
|
|
|
|
|
07-31-2016, 01:51 AM
|
#3 |
|
Registered User
Join Date: Jun 2011
Location: St Robert, Mo
Posts: 730
|
Re: WTB High Idle Switch
ttt...
|
|
|
|
|
11-20-2016, 03:51 PM
|
#4 |
|
Registered User
Join Date: Jun 2011
Location: St Robert, Mo
Posts: 730
|
Re: WTB High Idle Switch
Bump
|
|
|
|
|
07-04-2022, 03:05 AM
|
#5 |
|
Registered User
Join Date: Jun 2011
Location: St Robert, Mo
Posts: 730
|
Re: WTB High Idle Switch
ttt...
|
|
|
|
|
08-02-2022, 11:49 AM
|
#6 |
|
Senior Member
 Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,091
|
Re: WTB High Idle Switch
depending on your engine and trans you can do this with a single wire into the ECM powered off the brake switch. I know on my 03 duramax I ran the wire and would just have to set the parking brake then you would hit the cruise button for one set point and the resume button for a slightly higher set point. Tap the brakes and it would cancel out, if it was in gear it obviously wouldn't engage, cruise would work as normal.
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
