1964 GMC 1500 "crustine" semi- build.

[TJ's Chevy]

Originally Posted by caseyjones

You found a clutch at NAPA? I thought they are unobtainable. Care to share a part number?

Part number is 1104049 and is the 11 inch kit. Does not come with a flywheel and the disc splined nub will have to be ground down so the disc actually seats on the flywheel. Other than that it works great.

Originally Posted by Palf70Step

Originally Posted by cwcarpenter98

Nice! I bet the new trans makes it nicer to cruise around in

Yes sir it sure does! Now to ditch the 4.11 gears for some 3.55's. I'm toying with the idea of 4x4 converting this truck as I have a 77 ford f250 with a high pinion dana 44 front and a dana 60 rear with all the springs and steering. Everything should match up pretty well. Decisions decisions lol

[TJ's Chevy]

Spent some of last saturday doing some small stuff to the truck I've been wanting to knock out for awhile. Organized my tool box and installed some trays and a box for holding spare liquids. Also installed my air compressor for some air horns I bought years ago and finally decided to install on the truck.....they aren't To loud.
Now to plumb the air lines and wiring and make some noise. Hopefully the truck doesn't fall apart from the sound waves.

[caseyjones]

Originally Posted by TJ's Chevy

Part number is 1104049 and is the 11 inch kit. Does not come with a flywheel and the disc splined nub will have to be ground down so the disc actually seats on the flywheel. Other than that it works great.

Ah, thanks! - I'd heard you could modify a standard Chevy clutch, was hoping you found a new source for an off-the-shelf solution. But can't argue with your result, and I have an angle grinder

[TJ's Chevy]

Originally Posted by caseyjones

Ah, thanks! - I'd heard you could modify a standard Chevy clutch, was hoping you found a new source for an off-the-shelf solution. But can't argue with your result, and I have an angle grinder

Fur sure on the chevy clutch. Only issue you might run into is sometimes the disc spring plate sticks out to far on either side and might hit the flywheel. Angle grinder is what I used. lol

[TJ's Chevy]

Crustine pulled some weight the other day haha
Got myself a 2016 bumper pull with dual bedrooms.
She pulled it pretty good haha

[Ta2Don]

Very Cool T.J.

[TJ's Chevy]

Originally Posted by Ta2Don

Very Cool T.J.

Thanks Don! Good to see ya check in. How's things been going with you?