1963 L60 10 lug , want 22.5" wheels - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**JPBrecheisen** · 08-18-2023, 05:54 PM

Same.

I only ended up finding two and ended up just getting the ones from wheels now.

**CarolinaHD** · 08-18-2023, 07:44 PM

Quote:

Originally Posted by JPBrecheisen

Same.

I only ended up finding two and ended up just getting the ones from wheels now.

Were the wheel studs on the rear axle too short with the aftermarket wheels? I've read about some guys running into issues due to the aftermarket wheels being thicker than originals. I used 1 original and 1 aftermarket on my rear end and the stud is flush with the lugnut.

**JPBrecheisen** · 08-18-2023, 08:22 PM

I did run into the stud issue but only by a thread.

I keep an eye on them and have considered a shallower modern nut with the washer built in.

I don't run mine a lot but so far, no issues.

08-18-2023, 05:54 PM	#1
JPBrecheisen Senior Member Join Date: Jul 2012 Location: Harrisville, New York Posts: 459	Re: 1963 L60 10 lug , want 22.5" wheels Same. I only ended up finding two and ended up just getting the ones from wheels now. __________________ 1960 GMC K1500 LB Fleet Side 1962 GMC K1000 LB Step Side 1988 Chevrolet C2500

08-18-2023, 08:22 PM	#3
JPBrecheisen Senior Member Join Date: Jul 2012 Location: Harrisville, New York Posts: 459	Re: 1963 L60 10 lug , want 22.5" wheels I did run into the stud issue but only by a thread. I keep an eye on them and have considered a shallower modern nut with the washer built in. I don't run mine a lot but so far, no issues. Attached Images __________________ 1960 GMC K1500 LB Fleet Side 1962 GMC K1000 LB Step Side 1988 Chevrolet C2500



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.