![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#3 |
Registered User
Join Date: May 2015
Location: Tukwila Washington
Posts: 378
|
Re: 2001 2500hd 4x4 grinds while in 2wd high
Does the axle actuator disengage in 2wd? I may have had a similar issue with my '90 k1500. The 4wd didn't work one day, after ohming out some wires I replaced the actuator switch in the t-case. I was getting some binding in 2wd, not grinding. The new switch was bad, replaced it again and all was well. I took an ohm-meter to the parts store and tested the new switch there.
__________________
'47 Panel to '88 K2500 Frame Swap Mechanical Speedometer Drive Solution 1947.2 1 ton Chevy Panel 1955.2 Chevy 6700 Bus/RV 1990 Chevy K1500 |
![]() |
![]() |
Bookmarks |
|
|