|
05-26-2024, 09:18 PM | #1 |
Registered User
Join Date: Jun 2021
Location: Charleston, South Carolina
Posts: 34
|
Re: 1970 C10 project
I made some more progress, installed speed engineering headers.
Passenger side fit great, Driver side didnt really fit at all. I had to cut my engine mount bracket and dent the headers in several spots. I also went to a pick and pull and pulled two different Volvo electric power steering pumps. One with a built in reservoir and one without. The only place i think i can put it is near the core support. |
07-19-2024, 08:24 AM | #2 |
Registered User
Join Date: Jun 2021
Location: Charleston, South Carolina
Posts: 34
|
Re: 1970 C10 project
Made some more progress on the truck. I've decided to try and convert the harness to stand alone myself to save some money. So far I think that it'll work out. I have that done and all I have left is to wire up the fuel pressure control module so that I can use rhe Camaro's fuel pump.
I'm also re-wiring the truck from front to back and I'm finally at the point where I have lights. I bought a set of Dakota Digital Rtx gauges wirh their bim module. This was pricey bur worth it to save on wiring. |
07-19-2024, 05:09 PM | #3 |
Registered User
Join Date: Jul 2012
Location: tulsa oklahoma
Posts: 50
|
Re: 1970 C10 project
@lawreng do you think converting a 71/72 chevelle over to a 70 front clip and rear bumper will hurt the value in the long run if one decided to sell it? I have a bad fender on my 71 chevelle and really just want to throw a 70 front clip on it, but I know down the road I will sell the car and move onto a new project.
|
07-20-2024, 04:10 PM | #4 | |
Registered User
Join Date: Jun 2021
Location: Charleston, South Carolina
Posts: 34
|
Re: 1970 C10 project
Quote:
|
|
09-11-2024, 07:59 PM | #5 |
Registered User
Join Date: Jun 2021
Location: Charleston, South Carolina
Posts: 34
|
Re: 1970 C10 project
I made alot of progress in the last month. I finished the brake lines,
transmission cooler lines, and the fuel lines. The truck runs and drives now. I need to make a shroud for the Camaro 19 inch fan that doesnt take up too much room and to fabricate a cold air intake tube. |
Bookmarks |
|
|