Door Hinge Stop / Check Pads

[Rich72C10]

Originally Posted by leddzepp

That thread is in the FAQ section, all threads there are closed after they are cleaned up and consolidated.

Oh, gee - that's what I get for not looking in the Faq section - Doh!

[Rich72C10]

If you get the right tool, for the right job - sh*t will work!


TEKTON 3/16 Inch Roll Pin Punch #66066 off Amazon for $7.58 dollars. I also ordered a TEKTON 5/32 Inch Roll Pin Punch #66065 but its running late, it would have been useful pushing the later one back out.

I'd image all these days soaking with Free-All has helped but I hammered it from the top and down out of the bottom. The 1st few hits I didn't think it was going to move but then it did. After that only a 5 or so hits. I was using a regular claw hammer, so it isn't very heavy. Using a nice ball ping hammer likely would have been better.

Now to get the pads in but I'll do that tomorrow morning when it is cooler :-)