|
07-13-2024, 11:35 PM
|
#2 |
|
Senior Member
 
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,954
|
Re: Bell housing install?
I get some long bolts, like 5 inches or so, and cut off the heads (2 bolts needed). Then I cut a slot in them and chamfer the ends. I thread the bolts into the lower threads in the block. Now I have guide pins to help guide the bell housing into place. The slots allow me to use a screwdriver to remove them once the other bolts are in place.
__________________
I have sworn upon the altar of God, eternal hostility against every form of tyranny over the mind of man. - Thomas Jefferson |
|
|
| Bookmarks |
| Tags |
| 1/2 ton, 4 speed, 6 cyl |
|
|
Threaded Mode