Distributor/Points etc etc - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Loose Screw · Yesterday, 09:15 PM

Fixed!

**Rust_never_sleeps** · Yesterday, 10:06 PM

Working solo, I've strapped down the trigger on my timing light and laid it on the cowl so I could see it from the driver's seat. A plug tester would work also.
This way I could see when I at least had enough gap to make some kind of spark
Once I got it to run badly, I could set dwell with the meter, then set initial timing.

I had this problem because I had the type of points with the condenser onboard which got in the way of the feeler.

You might just be able to get a paper match in there for initial gap the old school way.

**Rust_never_sleeps** · Yesterday, 10:08 PM

sanding the points with a little bit of Emery paper first is a good start

Loose Screw · Today, 12:31 AM

Wired the Distributor wrong!

**Rust_never_sleeps** · Today, 01:34 AM

Quote:

Originally Posted by Loose Screw

Wired the Distributor wrong!

Yeah, that prolly didn't help ;-)

Yesterday, 09:15 PM	#1
Loose Screw Registered User Join Date: Jan 2024 Location: EL PASO Posts: 161	Distributor/Points etc etc Fixed! Last edited by Loose Screw; Today at 12:29 AM. Reason: Fixed!

Yesterday, 10:06 PM	#2
Rust_never_sleeps Senior Member Join Date: Jun 2022 Location: San Ramon,CA Posts: 476	Re: Distributor/Points etc etc Working solo, I've strapped down the trigger on my timing light and laid it on the cowl so I could see it from the driver's seat. A plug tester would work also. This way I could see when I at least had enough gap to make some kind of spark Once I got it to run badly, I could set dwell with the meter, then set initial timing. I had this problem because I had the type of points with the condenser onboard which got in the way of the feeler. You might just be able to get a paper match in there for initial gap the old school way. __________________ 1970 C10 Custom longbed 350/350

Yesterday, 10:08 PM	#3
Rust_never_sleeps Senior Member Join Date: Jun 2022 Location: San Ramon,CA Posts: 476	Re: Distributor/Points etc etc sanding the points with a little bit of Emery paper first is a good start __________________ 1970 C10 Custom longbed 350/350

Today, 12:31 AM	#4
Loose Screw Registered User Join Date: Jan 2024 Location: EL PASO Posts: 161	Re: Distributor/Points etc etc Wired the Distributor wrong! Last edited by Loose Screw; Today at 12:32 AM. Reason: Fixed!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.