1970 C10 project

[lawrenq]

Made some more progress on the truck. I've decided to try and convert the harness to stand alone myself to save some money. So far I think that it'll work out. I have that done and all I have left is to wire up the fuel pressure control module so that I can use rhe Camaro's fuel pump.

I'm also re-wiring the truck from front to back and I'm finally at the point where I have lights. I bought a set of Dakota Digital Rtx gauges wirh their bim module. This was pricey bur worth it to save on wiring.

[99_Sierra]

@lawreng do you think converting a 71/72 chevelle over to a 70 front clip and rear bumper will hurt the value in the long run if one decided to sell it? I have a bad fender on my 71 chevelle and really just want to throw a 70 front clip on it, but I know down the road I will sell the car and move onto a new project.

[lawrenq]

Originally Posted by 99_Sierra

@lawreng do you think converting a '71/'72 Chevelle over to a '70 front clip and rear bumper will hurt the value in the long run if one decided to sell it? I have a bad fender on my '71 Chevelle and really just want to throw a '70 front clip on it, but I know down the road I will sell the car and move onto a new project.

No, I don't think it'll hurt the value at all. I think it would be easier to sell. That's what I did with my Chevelle; it's actually a '71. I'm also doing the same with my truck by putting a '68 front clip on it. As long as it's not a numbers-matching SS, most people prefer the look of the '70.