![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Nov 2014
Location: Virginia Beach, Virginia
Posts: 83
|
Re: 1978 C20 Drive Shaft Center Seal
I cut a gasket to fit (1.75 OD x 1.25 ID) of 1/16 inch rubber. It fit, but 1/16 inch thickness was not a correct choice. Grease from the fitting blew it out. The next one I make will be 1/8 inch thick.
Edit: I made an 1/8 inch thick one. It does not blow out as early as the 1/16 did, so it is better but not yet good. Last edited by Robert Crandall; 07-23-2024 at 05:06 PM. Reason: New gasket, new thickness |
![]() |
![]() |
![]() |
Bookmarks |
|
|