![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Dec 2013
Location: clovis NM
Posts: 10
|
69 C10 with a 6l90 transmission HELP
Hoping to get some help. I have read that when putting a 6l90 that I would need to cut the floor and use the high hump. So I did that and put the cab in the frame and as you can see by the pic the end shaft and the 3 bolt flange are inside the cab. I have Holley motor mounts and tinworks frame stiffener with trans mount. I don’t know the angle of the engine and transmission. I know it should be 3 deg I just don’t know if that will give me the clearance I need. Let me know what I need to do. TIA
Last edited by reddogg; Today at 08:26 AM. Reason: Added pic |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2008
Location: Md
Posts: 2,462
|
Re: 69 C10 with a 6l90 transmission HELP
Not the same as your application, but mine took 3 different motor mount combinations before getting engine placement correct.
.. More information needed for others to help solve your dilemma. Photos also get you better responses.....good luck.
__________________
http://67-72chevytrucks.com/vboard/s...d.php?t=635605 |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2013
Location: clovis NM
Posts: 10
|
Re: 69 C10 with a 6l90 transmission HELP
Pic
Last edited by reddogg; Today at 08:44 AM. |
![]() |
![]() |
![]() |
Bookmarks |
|
|