Advice needed - timing chain

[kev2809]

I put everything back together and it's sitting on the stand ready to go in, I just got the old engine out yesterday. but yes, the dots seemed ok, just the corresponding teeth looked a little off. but while putting the harmonic balancer and pulley back and tightening them down, the timing line from the timing cover was a little off on the balancer timing line too, seemed even more than the dots. now, the balancer COULDVE moved while tightening the bolt...but I don't remember checking before putting the balancer on


so..I guess my question is...what IF it's a little off...will it run poorly? I should've taken a picture to show the fraction I seen!