![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#3 |
low n' slo
![]() Join Date: Mar 2009
Location: rosenberg, texas
Posts: 5,167
|
Re: Advice needed - timing chain
I put everything back together and it's sitting on the stand ready to go in, I just got the old engine out yesterday. but yes, the dots seemed ok, just the corresponding teeth looked a little off. but while putting the harmonic balancer and pulley back and tightening them down, the timing line from the timing cover was a little off on the balancer timing line too, seemed even more than the dots. now, the balancer COULDVE moved while tightening the bolt...but I don't remember checking before putting the balancer on
so..I guess my question is...what IF it's a little off...will it run poorly? I should've taken a picture to show the fraction I seen!
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread ![]() -_--_--_ _________ _--_-_ -/____|__|__\__ ,.,,,.,.,,.,|_O _______ O_] Last edited by kev2809; 08-01-2024 at 08:20 AM. |
![]() |
![]() |
Bookmarks |
|
|