|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-28-2024, 04:17 PM
|
#1 |
|
Registered User
Join Date: Sep 2011
Location: Maryville TN
Posts: 201
|
Factory ride height blazer
I'm looking for some measurements so i can determine what the lift is on my blazer project. Its a 1984 and the po had the truck lifted a pretty good amount. If someone could get me a measurement from the center of the axle to the fender lip that would be great. The rear springs have a pretty serious arc to them and the rear end is tilted so the lift must be pretty significant. Thanks!
Hal |
|
|
|
08-30-2024, 11:27 AM
|
#2 |
|
Active Member
 
Join Date: Jan 2017
Location: Traverse City, MI
Posts: 191
|
Re: Factory ride height blazer
I just purchased a 1988 Blazer still with the stock suspension, I will get some measurements this weekend.
|
|
|
|
|
08-31-2024, 09:27 PM
|
#3 |
|
Active Member
Join Date: Jan 2017
Location: Traverse City, MI
Posts: 191
|
Re: Factory ride height blazer
I measured the front end - 23-1/2 inches from the center of the front axle to the bottom of the fender. This does have the 3 leaf HD spring rather than the 2 leaf stock but that should be minimal increase is height. If you need a back measurement, let me know.
I got a chance to measure the rear when it was not so dark out - the rear is 20-1/2 from center of axle to bottom of wheel well opening. Last edited by THI; 09-01-2024 at 09:17 AM. |
|
|
|
|
09-01-2024, 04:29 PM
|
#4 |
|
Registered User
Join Date: Sep 2011
Location: Maryville TN
Posts: 201
|
Re: Factory ride height blazer
That's great thanks so much for the info! Now i can figure out what the PO did for a lift and take it from there. Winter project here i come.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
