Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
09-02-2024, 09:13 AM | #1 |
Registered User
Join Date: Aug 2016
Location: Guthrie, OK
Posts: 51
|
Re: Need measurements for C30 dually rear axle
Found a post on another board that said the Dana 70 was 72 inches flange to flange.
Don't know if that is the standard or the wide. It would be too wide to fit under my truck. Anyone have flange to flange on the other Dana 70 dually rear? You can see from this pic, I could stand to go a little bit wider, but not much. I don't want any part of the wheel/tire outside from under the bed. |
09-02-2024, 12:14 PM | #2 |
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,573
|
Re: Need measurements for C30 dually rear axle
If you can get the adapters for the rims they are large enough to clear the drums on a single wheel 14 bolt- (67'' wide). May have to move the spring perches, but that's not a big deal. Gear availability on a 14 bolt ----3.42, 3.73, 4.10, 4.56, 4.88, 5.13, 5.38 and a 3.21 (if you can find a set)
|
Bookmarks |
|
|