|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
Yesterday, 10:40 AM
|
#1 |
|
Registered User
Join Date: Jun 2019
Location: Chehalis, WA
Posts: 24
|
kinda desperate for driveshaft :(
My Denny's driveshaft grenaded when the carrier bearing failed and they don't make 2-piece driveshafts anymore. I haven't been able to find ANYONE that makes these new or refurb, so I guess I gotta find a stock one and rebuild it myself.
just checking in to see if anyone knows a source for new or used before I start looking around. '72, 2WD, longbed, coil spring, TH350. Last edited by Willshook; Yesterday at 02:08 PM. |
|
|
|
Yesterday, 04:47 PM
|
#2 |
|
Registered User
Join Date: Feb 2013
Location: central California
Posts: 2,744
|
Re: kinda desperate for driveshaft :(
Pretty sure these guys can help you out https://www.dlsofstockton.com/
|
|
|
|
|
Today, 12:06 PM
|
#3 |
|
Senior Member
 Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,058
|
Re: kinda desperate for driveshaft :(
Reach out to a local trans builder or big truck & equipment repair shop. They will know who makes drive shafts near you and can build you a two piece.
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
|
|
|
|
Today, 04:11 PM
|
#4 |
|
Registered User
Join Date: Jun 2019
Location: Chehalis, WA
Posts: 24
|
Re: kinda desperate for driveshaft :(
Found these folks in Seattle and they were awesome. They can make anything, and they were able to rehab an old, dead shaft I had.
https://www.drivelinesnw.com/ |
|
|
|
|
Today, 04:47 PM
|
#5 |
|
Registered User
Join Date: Dec 2003
Location: lake forest park, Washington
Posts: 265
|
Re: kinda desperate for driveshaft :(
I have used drivelines northwest in Everett WA
__________________
-1971 K20 350/sm465 -2004 1500 |
|
|
|
|
Today, 05:17 PM
|
#6 |
|
Registered User
Join Date: May 2009
Location: Motor City
Posts: 9,207
|
Re: kinda desperate for driveshaft :(
Would this be a good time to consider a one piece?
The original two piece was designed to cover all drivers in all situations at all speeds with all option content for the life of the vehicle (or more). Depending on your tire size, rear axle ratio and driving style (how fast are you planning on going?) a one piece might do. K
__________________
Chevrolet Flint Assembly 1979-1986 GM Full Size Truck Engineering 1986 - 2019 Intro from an Old Assembly Guy: http://67-72chevytrucks.com/vboard/s...d.php?t=342926 My Pontiac story: http://forums.maxperformanceinc.com/...d.php?t=560524 Chevelle intro: http://www.superchevy.com/features/s...hevy-chevelle/ |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
