|
09-24-2024, 02:07 PM
|
#6 |
|
Registered User
Join Date: May 2011
Location: Anderson SC
Posts: 3,897
|
Re: 250 cyl head????
To figure out how much to mill to get a certain chamber volume, use a graduated cylinder to measure out that many cc of water (add a drop of dish soap), level the head, add that water to the chamber, then measure down to the water level.
Not sure, but there might be thinner head gaskets available that would also help bump the compression up. If you can find them, flat top 307 pistons work great to bring compression up.
__________________
Project Goldilocks '66 C10 Short Fleet BBW Build '65 C10 Highly Detailed Stock Restoration Thread '78 Camaro Targa Roof Build '55 International Metal/Body/Paint Work '66 F100 Full Rotisserie Restoration '40 Packard 120 Convertible Coupe Restoration How To Restore and Detail an Original Gauge Cluster How To Detail Sand Body Panels, Edges, Corners, Etc |
|
|
| Bookmarks |
|
|
Threaded Mode