Quote:
Originally Posted by raggedjim
I recently put a jeep shaft in. The shaft comes with 3/4" splined on one end and 1" dd on the other end.
Your steering box is probably 13/16 splined, but I'm not 100% on this. I had to ream the shaft to get it to fit. I think the 79 up steering box is a 3/4" splined so if you could use one of those you could skip a bunch of reaming.
I also welded a piece of the original collapsible shaft to use as a bushing to go from 3/4" dd to 1" dd at the end of the steering column shaft https://67-72chevytrucks.com/vboard/...&postcount=118
Good luck, Rg
|
So the steering column spline is most likely 3/4. I measured around .74. The gearbox is .799 which is 13/16” as you mentioned? Would they both be 36 spline? Once I know, I’ll get the parts ordered. The rag joint was terrible - the bolt was stripped and I had to drill the whole thing out.