|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-13-2024, 08:35 PM
|
#1 |
|
Registered User
Join Date: Oct 2013
Location: Central Coast Ca.
Posts: 419
|
71 rear brake cylinder interference question
Greetings
Replaced the rear shoes and cylinders on my 71 C10 1/2 ton. My question has to do with the way the rubber seal on the cylinders is 'squished' by the locating brackets/pivot. The replacement cylinders had the same interference issue with the bracket. Is this normal and 'just the way it is'? It certainly works but the boot is somewhat distorted and just doesn't seem right to me. I'm trying to upload a pic of the original cylinder and seal but the replacement looked identical. I was slightly tempted to grind off the offending bracket a bit but thought 'it worked like that for x years so it must be okay'. Any hints/comments???
__________________
1971 SWB step side: Original NM Forestry truck, then NM Fire truck, and now a ranch truck. Last edited by Carl Spangler; 10-13-2024 at 09:27 PM. |
|
|
|
10-13-2024, 10:24 PM
|
#2 |
|
Who Changed This?
 
Join Date: Jan 2013
Location: Simi Valley, CA
Posts: 10,548
|
Re: 71 rear brake cylinder interference question
That's fine. It won't hurt a thing. That is only a dust boot.
__________________
~Steven '70 Chevy 3/4T Longhorn CST 402/400/3.56 Custom Camper Simi Valley, CA |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
