Clutch Z-bar alignment

[pjmoreland]

Originally Posted by Detour

I know the motor isn't original, it's a mix of older full size car parts but it seems to be healthy. Also don't know for sure what the original engine was, but was told it was a 327.
I know the frame side bracket is on correct because I drilled and chiseled the factory rivets off.
How would the engine be sitting to low? This is how I felt while looking at it, but the mounts don't look collapsed vs pictures of new ones I see online.
The upper clutch rod is worn almost halfway through, but haven't found a replacement online. May have to weld the gap up and grind to size.

Does your engine crossmember look like this one?



http://67-72chevytrucks.com/vboard/s...d.php?t=634117