|
11-03-2017, 09:15 AM | #1 |
Registered User
Join Date: Feb 2013
Location: Cottonwood, Arizona
Posts: 1,375
|
Re: What did you do to your truck today part IV
pulled all the window trim pieces and my glove box door out to repaint them all.
I have to stop using my Suburban to move. It's getting very tiring sanding and fixing the scratches for repaint. This is the last time and trying to get the interior done before next Saturday for the Walkin' on Main Car Show put on by the Mingus Union High School Auto Club. |
11-03-2017, 09:59 AM | #2 |
It's Better With Nitro
Join Date: Apr 2008
Location: Chino Hills, CA
Posts: 2,261
|
Re: What did you do to your truck today part IV
Had some pin striping done on the rear of the cab and leading edge of the hood...
__________________
1963 C-10: Deluxe-optioned cab, shortbed, fleetside Pontiac 462 ci, Kauffman D-Port alum. heads 4L80E, narrowed sheetmetal Ford 9-inch Tubular front and rear suspension Custom 6-piston front disc and 4-piston rear disc brakes |
11-03-2017, 10:22 AM | #3 |
1962 C-10
Join Date: Apr 2005
Location: Las Vegas, New Mexico
Posts: 4,978
|
Re: What did you do to your truck today part IV
Very cool!!
__________________
Joseph Chavez "See the USA in a Chevrolet!!" ......................_____ .........________//__{\_____ ,,,,,,,/__(O)___//___/__(O)_/ 1962 C10 Shortbed Fleetside 327/th350 GV overdrive 1974 C10 Longbed Fleetside 350/th350 "The Trash Truck" 1999 Chevy 2500 OBS, Longbed 5.7/4L80E 4x4 2015 GMC Sierra SLE 1500 4x4 |
11-03-2017, 01:45 PM | #4 |
Registered User
Join Date: Feb 2013
Location: Cottonwood, Arizona
Posts: 1,375
|
Re: What did you do to your truck today part IV
|
11-04-2017, 11:59 AM | #5 |
Senior Member
Join Date: Aug 2011
Location: Reno, Nv.
Posts: 1,430
|
Re: What did you do to your truck today part IV
Very NICE!!!!
__________________
1927 Willy's Knight 24,000 original miles, 1958 Impala 283/Powerglide, 1964 C-30 383/4 speed, 1971 Monte Carlo 350/350, 1972 GMC K2500 350/350, 1976 Chev. K10 350/350, 2006 GMC Sierra 2500HD LBZ Duramax/Allison, 2006 Chev. Silverado K3500 LBZ Duramax/Allison |
12-12-2017, 12:00 AM | #6 |
Registered User
Join Date: Feb 2017
Location: Desoto mo
Posts: 106
|
Re: What did you do to your truck today part IV
I did a tape measure wheel alignment and took my truck for its first drive in almost three years. I upgraded to disc brakes, which turned into a crossmember swap. I added power steering, I wanted to run a later model serpentine setup. The one I found was attached to a 95 tbi motor with the 4l60e, naturally I left it attached and put the whole lot in. Cut up the original harness and stripped out what I didn't need, made it a couple feet shorter. The whole thing got out of hand. Everything was done on a shoestring budget. It runs and drives amazing, the overdrive is awesome. Still have a bunch of stuff to do but it runs and drives finally, going to make it a daily driver, it was before the upgrades with the original 283 stick.
|
11-21-2017, 07:22 PM | #7 |
Registered User
Join Date: Oct 2017
Location: Tucson
Posts: 1
|
Re: What did you do to your truck today part IV
Rescued a 1964 fleet-side from rotting in someones yard, this will be my first build. Looking forward to the sweet and blood and tears complete frame off. signed up as this looks to be the place for Chevy info. so to answer the question what did i do my chevy today? power wash the pack rats nest and rat feces out of every crevice of this truck.
|
11-21-2017, 08:12 PM | #8 |
Registered User
Join Date: Sep 2006
Location: San Francisco
Posts: 4,779
|
Re: What did you do to your truck today part IV
I was finally able to install one of the Saginaw 3 speed OD transmission's I have. Have to get the drive shaft shortened as this trans is 5" longer then my stock one.
__________________
"A man and his truck, what a beautiful thing" 65 Short Fleetside BBC 65 Long Fleetside 283 3 on the tree for now. my build thread http://www.67-72chevytrucks.com/vboa...d.php?t=259536 |
12-05-2017, 08:30 PM | #9 |
Registered User
Join Date: Jul 2017
Location: Bunker Hill, WV
Posts: 127
|
Re: What did you do to your truck today part IV
got my new tires installed
__________________
Dan "Ratman" Ratcliffe Fourth generation Chevy truck guy, raising the fifth 1978 Scottsdale Big 10 "Bad Medicine" Daily Driver 28 yrs 1965 C10 Panel Truck "RWC" http://www.67-72chevytrucks.com/vboa...d.php?t=749003 |
12-06-2017, 08:47 PM | #10 |
Registered User
Join Date: Mar 2007
Location: Fawn Lodge, Ca.
Posts: 293
|
Re: What did you do to your truck today part IV
Drove the old man into town to do errands. I do get tired spending an hour outside O'Reilly's trouble-shooting the tail lights... This time it seems to have been a fuse... I think.
|
12-07-2017, 07:24 PM | #11 |
Registered User
Join Date: Jul 2017
Location: Bunker Hill, WV
Posts: 127
|
Re: What did you do to your truck today part IV
put the new wheels and tires on
__________________
Dan "Ratman" Ratcliffe Fourth generation Chevy truck guy, raising the fifth 1978 Scottsdale Big 10 "Bad Medicine" Daily Driver 28 yrs 1965 C10 Panel Truck "RWC" http://www.67-72chevytrucks.com/vboa...d.php?t=749003 |
12-09-2017, 07:58 PM | #12 |
Registered User
Join Date: Feb 2013
Location: Cottonwood, Arizona
Posts: 1,375
|
Re: What did you do to your truck today part IV
Removed the last 2 pieces of the original "headliner" material out of my Sub. Found a nice rusty spot above the dome light from where I had a magnetic XM Radio antenna mounted with the cord run through the roof. Going in for knee surgery the 18th, so trying to clean up the roof so I can paint the inside of the roof with oil base paint, then get some foil backed foam from Home Depot to put on it. Will have a custom headliner made after the truck gets painted, from a friend who does custom work here in the Verde Valley. Got some of the inside sanded today and removed the 2 6X9 speakers. I didn't realize how long the bedsides were until I started sanding them.
Last edited by 65chevysub; 12-10-2017 at 09:06 PM. |
12-10-2017, 02:41 PM | #13 |
Registered User
Join Date: Feb 2015
Location: San Diego, CA
Posts: 409
|
Re: What did you do to your truck today part IV
Pulled the blower and made my own gasket because all the speed shops are closed and usually don't carry them anyways. Install a new msd 8570 and set the timing. My old distributor was so rusty it wouldn't advance. I pop the cap once in a while to look but I didn't think it was that bad. All in all it's been a good weekend and the truck is flying again!
__________________
At my worst I'm at my best |
12-10-2017, 07:26 PM | #14 |
Registered User
Join Date: Sep 2017
Location: Red Oak Iowa
Posts: 225
|
Re: What did you do to your truck today part IV
Pulled what was left of the inline six and three speed manual trans out. Probably just a few nice days left then I am done for the season, don't have a heated shop.
|
12-10-2017, 09:17 PM | #15 |
Senior Member
Join Date: Jan 2015
Location: Tampa, Fl.
Posts: 423
|
Re: What did you do to your truck today part IV
I got my new under bed tank installed and plumbed. Works great. Took it for a test drive and blew out a brake line. Bought new brake lines, haven't installed yet.
|
12-15-2017, 09:07 PM | #16 |
Registered User
Join Date: Sep 2006
Location: San Francisco
Posts: 4,779
|
Re: What did you do to your truck today part IV
My truck had one West Coast Jr Mirror when I bought it. It has been giving me trouble for a while now and if finally broke at the bottom from rusting out, so I went with a stock mirror for now. I just put it on today and had to drill out the old screws that were in there for 50 plus years. I soaked them with oil and even tried heat but it was burning the paint Oh fun. I will probably paint them white. I saved the old mirror and maybe I can weld it back together. I had to use Gorilla Tape to keep it together.
__________________
"A man and his truck, what a beautiful thing" 65 Short Fleetside BBC 65 Long Fleetside 283 3 on the tree for now. my build thread http://www.67-72chevytrucks.com/vboa...d.php?t=259536 |
12-15-2017, 11:24 PM | #17 |
Registered User
Join Date: Jun 2015
Location: Moose Jaw, SK
Posts: 510
|
Re: What did you do to your truck today part IV
Shiny black looks pretty sharp, in pictures anyways.
__________________
1961 GMC half ton, short step, Canadian model. Just starting work on it. |
12-16-2017, 08:41 AM | #18 |
Registered User
Join Date: Oct 2015
Location: Keller, tx
Posts: 426
|
Re: What did you do to your truck today part IV
Started repairing cancer in fenders
|
12-18-2017, 03:49 AM | #19 |
Registered User
Join Date: Feb 2017
Location: Desoto mo
Posts: 106
|
Re: What did you do to your truck today part IV
Finished up a few details, going to go get a safety inspection and renew the tags. They've been expired 2 1/2 years. Power disc brakes snowballed considerably. I gutted a 1995 Silverado for its drivetrain and installed the whole lot in my 63, harness, computer and all. The fuel injection works perfect. Tbi 5.7 4l60e should do decent on gas. If you know how to solder, cutting up and reworking the harness is not too bad. Took about 4 hours the first time. I think I can do the next one in 2 now that I've worked a few things out. The 88-95 obd1 trucks are fairly easy to work with and super cheap.
|
12-18-2017, 11:59 AM | #20 |
Registered User
Join Date: Mar 2014
Location: Salinas Ca.
Posts: 625
|
Re: What did you do to your truck today part IV
went from this
to this |
12-18-2017, 12:12 PM | #21 |
Registered User
Join Date: Oct 2016
Location: san bernardino ca
Posts: 1,611
|
Re: What did you do to your truck today part IV
Wow, Its off the rack. Very nice you guys do nice work.
|
12-18-2017, 12:35 PM | #22 |
Registered User
Join Date: Dec 2017
Location: Henderson
Posts: 17
|
Re: What did you do to your truck today part IV
lowered the burb a little bit more, put newer wide whites and added some caps.
next is to tackle rest repair.... [ATTACH][/ATTACH] |
12-18-2017, 07:01 PM | #23 |
Registered User
Join Date: Dec 2017
Location: Forest Grove OR
Posts: 15
|
Re: What did you do to your truck today part IV
Traced out an electrical issue with my '65 C20.
Last edited by GreyFox; 12-18-2017 at 07:04 PM. Reason: Adding picture |
12-24-2017, 02:25 PM | #24 | |
But Found Her 25yrs Later!
Join Date: Oct 2010
Location: Oregon City, Oregon
Posts: 10,523
|
Re: What did you do to your truck today part IV
Quote:
__________________
I lost my 65 - Found it 25 years later: http://67-72chevytrucks.com/vboard/s...d.php?t=426650 66 C20 Service Truck: http://67-72chevytrucks.com/vboard/s...d.php?t=428035 |
|
12-24-2017, 06:04 PM | #25 |
Registered User
Join Date: Dec 2017
Location: Henderson
Posts: 17
|
Re: What did you do to your truck today part IV
67-68 gmc caps yeah I’ve always liked them and got a killer deal on em. Kinda hard to find.
|
Bookmarks |
|
|