|
11-25-2009, 12:09 PM | #1 |
Sunburst C10!!!
Join Date: Jan 2009
Location: Texas
Posts: 2,560
|
Re: What did you do to your truck today?
__________________
Gage 1967 C10 Shortbed Stepside |
11-25-2009, 03:10 PM | #2 |
Registered User
Join Date: Oct 2006
Location: San Jose NOR*CAL
Posts: 3,080
|
Re: What did you do to your truck today?
Fixed the oe turn signal switch swaped out antenna, and started sanding down dash
__________________
1960 Apache long bed fleet L6 250 Clifford intake 2 bbl carb. Langdon cast headers with dual exhaust and bellflower tips. T-5 5 speed, power steering and power disc brakes. "Over, Around or through it... " Last edited by slepysal; 11-26-2009 at 01:16 AM. |
11-25-2009, 09:05 PM | #3 |
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What did you do to your truck today?
I got the 63 rear suspension all finished up today. Installed ECE shock relocator kits. Built all new brake lines for the back half of the truck.
I also rigged up a temporary fuel tank so I could start the engine. Found bad deal. When I assembled the new engine into the truck, I forgot to change the throwout bearing. The original throwout bearing was the long one and my new clutch needs the short one. So, my clutch is stuck disengaged. Friday I will have to pull the trans and swap the bearing to the right one.
__________________
I'm on the Instagram- @Gearhead_Kevin |
11-26-2009, 12:15 AM | #4 |
HOW long until spring??
Join Date: Mar 2009
Location: Star Idaho
Posts: 1,413
|
Re: What did you do to your truck today?
UPS guy came bringing more parts. He always has to check out the progress as he stops here fairly often. Happy Thanksgiving everybody!!
__________________
69 chevelle convertible 71-C-10 short-wide and low 64 C-10 custom shortbox "Bubba"s Recycling project" |
11-26-2009, 01:15 AM | #5 |
Registered User
Join Date: May 2009
Location: Loganville, Ga.
Posts: 1,408
|
Re: What did you do to your truck today?
It's been almost 7 years and I finally started the old wore out bone stock 350........cough, cough.
Run it for about 20 minutes tonight and broke the cam in, motor sounds very, very, healthy. Last edited by 198plus; 12-03-2009 at 11:53 PM. |
11-26-2009, 01:35 AM | #6 |
Sunburst C10!!!
Join Date: Jan 2009
Location: Texas
Posts: 2,560
|
Re: What did you do to your truck today?
is that carb workin good
__________________
Gage 1967 C10 Shortbed Stepside Last edited by jgh64pkup; 11-26-2009 at 01:36 AM. |
11-26-2009, 01:51 AM | #7 |
Registered User
Join Date: May 2009
Location: Loganville, Ga.
Posts: 1,408
|
Re: What did you do to your truck today?
Oh yea........very quick throttle response........
Last edited by 198plus; 11-26-2009 at 10:54 AM. |
11-26-2009, 05:41 AM | #8 |
Account Suspended
Join Date: May 2005
Location: Kansas City, KS
Posts: 3,906
|
Re: What did you do to your truck today?
Loaded Jon C's big back window cab and some other items. Headed from KC to Alabama on Thursday night/Friday morning at 1:30 am. Twenty-one hours, round trip. Should be lots of fun.
|
11-26-2009, 09:09 AM | #9 |
Account Suspended
Join Date: Sep 2009
Location: High Plains of Colorado
Posts: 2,485
|
Re: What did you do to your truck today?
Started installing new bucket seats in my 65 SWB SS. Made seat brackets out of 11 ga. 1-1/2 square tube and 1-1/2 x 1 rectangular tubing.
Next up is retractable seat belts..... then interior paint. Happy Turkey Day Gang! (and thanks to Markeb for his internet help with the seats) |
11-26-2009, 07:26 PM | #10 |
Registered User
Join Date: Apr 2009
Location: Kansas City,MO
Posts: 323
|
Re: What did you do to your truck today?
OK here are the pics I put the bumper on painted it remounted the plate remounted the drag plate and got some 65 style caps
And my lil girl on her girly Lowrider bike...
__________________
96 Burban Sold 99 Z71 Sold 65 C10 Sold 72 C10 Sold 87 Short Bed Lowered Daily Driver http://s623.photobucket.com/albums/tt314/sswagon/ http://www.chevygmcofkc.org/forums/forum.php |
11-27-2009, 02:22 PM | #11 |
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What did you do to your truck today?
Drove the farm truck for the first time today. I still need to finish the gas tank and install the seat, bleed brakes, align the front end and install the wheels. New wheels and powdercoated grille and bumpers are going to make the difference.
MarK bed wood and strips to be here some time next week.
__________________
I'm on the Instagram- @Gearhead_Kevin Last edited by Tx Firefighter; 11-27-2009 at 02:23 PM. |
11-28-2009, 12:35 AM | #12 | |
Senior Enthusiast
Join Date: Feb 2007
Location: Spokane Valley, WA
Posts: 8,356
|
Re: What did you do to your truck today?
Quote:
My big truck adventure today was pulling the car cover off and taking a 15 minute drive to make sure the STA-BIL got circulated up to the carb. |
|
11-28-2009, 02:13 AM | #13 |
Registered User
Join Date: Apr 2009
Location: Kansas City,MO
Posts: 323
|
Re: What did you do to your truck today?
I know that guy gets so much crap done i feel lazy over here lol I need to get off my @$$ and off this site that keeps me up all night!
Tx Firefighter love that Avatar
__________________
96 Burban Sold 99 Z71 Sold 65 C10 Sold 72 C10 Sold 87 Short Bed Lowered Daily Driver http://s623.photobucket.com/albums/tt314/sswagon/ http://www.chevygmcofkc.org/forums/forum.php |
11-27-2009, 07:04 PM | #14 |
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What did you do to your truck today?
Twenty years ago when I started goofing with old trucks, I would put Saddleman saddle blanket type seat covers on my trucks. They were very durable and lasted forever.
On this farm truck, I wanted to run one like I did back then. Everywhere I looked though, all I can find is thin versions of the old saddle blanket covers. Finally, I found a guy on ebay who makes them. I was pleasantly surprised when it arrived. It's at least the weight and thickness of the ones I bought in the 80s. The downside is that it has some funny corner flaps on the front sides of it. The girlfriend says she will sew them down for me. The seat is a 73-87 Suburban middle seat I think. It's a bit narrower than most bench seats, allowing a bit of room between the edge of the seat and the doors. I spent some time lowering the brackets even more. I like my seats real low.
__________________
I'm on the Instagram- @Gearhead_Kevin Last edited by Tx Firefighter; 11-27-2009 at 07:06 PM. |
11-28-2009, 12:07 AM | #15 |
Senior Member
Join Date: Nov 2008
Location: Glendora, CA
Posts: 6,338
|
Re: What did you do to your truck today?
I changed the oil on my '46 for the first time since I've owned it. Good thing I did because it was BLACK! Whoever the A-Hole was that put the oil filter on last time put it on SO FRIGGIN TIGHT, I destroyed the filter; well, I caved it in with my filter wrench and broke the wrench in doing it! Anyway, its belly is full of nice clean oil now. NEXT...
|
11-28-2009, 02:32 AM | #16 |
Account Suspended
Join Date: May 2005
Location: Kansas City, KS
Posts: 3,906
|
Re: What did you do to your truck today?
Once again, I am not able to download photos because my Sprint MiFi card can't keep the connection long enough...note to everyone, don't give Sprint a dime of your money...this and their other phone services are terrible. I can't wait to be done with my contract!
Anyway, I left Kansas City at 8:30 pm on Thanksgiving evening and drove 655 miles in 11 hours to Moulton, AL, to deliver the big back window, A/C cab to Jonathan Cross. I arrived at 7:30 am, took a few hour power-nap, drove to his place, unloaded, chatted about trucks for a while and headed back to KC. I just walked in the door at 12:00 midnight. 1,330 miles and 21.5 hours of driving in the last 27.5 hours. I should sleep good tonight. |
11-28-2009, 02:32 AM | #17 |
Account Suspended
Join Date: May 2005
Location: Kansas City, KS
Posts: 3,906
|
Re: What did you do to your truck today?
Brian:
Your rig is looking good. |
11-28-2009, 03:54 AM | #18 |
Registered User
Join Date: Jun 2009
Location: Winnipeg, MB Canada
Posts: 31
|
Re: What did you do to your truck today?
Well today I went to an autowrecker about an hour from
My house. My friends dad and I went there looking for front fenders and although there were 6 different trucks I had no luck as all were rusted out. I did however, manage to find a factory rearview mirror from a 64. I'll be putting it my 62 as I've been looking for one for nearly 2 months. Just wondering though, how much would this one be worth? It's in fair condition, although it needs a good polishing. The rivets also have surface rust on them. |
11-28-2009, 10:11 AM | #19 |
1# Drobmember in Germany
Join Date: Aug 2008
Location: Wuppertal , Germany
Posts: 518
|
Re: What did you do to your truck today?
today i changed the Wheels and the Steeringwheel......
before....... after........ and before...... and after..... Pat |
11-28-2009, 06:59 PM | #20 |
chevy only
Join Date: Sep 2006
Location: Phoenix, AZ
Posts: 6,619
|
Re: What did you do to your truck today?
pat when did you get this!!!
__________________
CHEVY ONLY... Nothin Else ! |
11-28-2009, 07:24 PM | #21 |
1# Drobmember in Germany
Join Date: Aug 2008
Location: Wuppertal , Germany
Posts: 518
|
Re: What did you do to your truck today?
nice , whats happend to the burb??
Hey Dino , i bought the burb in mid September from a Guy in Nebraska and the burb arivied 3 Weeks ago ! this burb is sick !!!!! look here http://67-72chevytrucks.com/vboard/s...d.php?t=361897 Pat |
11-28-2009, 07:28 PM | #22 |
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What did you do to your truck today?
I lost the Suburban in a divorce actually. A member on here bought it and is actually doing a build thread on it somewhere.
__________________
I'm on the Instagram- @Gearhead_Kevin |
11-29-2009, 01:05 AM | #23 |
Registered User
Join Date: Jan 2007
Location: Denton, Texas
Posts: 356
|
Re: What did you do to your truck today?
Cut a chunk out of my frame for the c-notch. Still gotta make the cuts on the other side and then weld everything up. There's just not enough time in the day.
But I also had to spend some time getting my new toy ready to race tomorrow('06 KTM 200XC).
__________________
Andrew '69 C-20(292, 4-speed) Retired Daily Driver '64 C-10(250, 3-speed) Fixerupper '97 F*rd Mustang GT(4.6L, 5-speed) Daily Driver If I only wanted two pedals I'd have bought a bicycle.
|
11-28-2009, 12:09 PM | #24 |
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: What did you do to your truck today?
Your Suburban reminds me of one I used to own.
__________________
I'm on the Instagram- @Gearhead_Kevin |
11-28-2009, 12:58 PM | #25 |
The Beach Cruiser
Join Date: May 2009
Location: Panama City, Florida
Posts: 358
|
Re: What did you do to your truck today?
I wrote the date in the dust. Next week it gets attention
__________________
1999 Silverado DD 1966 Panel Truck 2003 Harley Road Glide 1967 Schwinn Tandem Single Speed |
Bookmarks |
|
|