Got a new truck

[onlyifihadachevy]

were getting the seat in place and then lowering the motor if need As it sits it is at the center of the windsheild area.. The shock are going down 4ins and that is a hih rise and we're going to use a low rise.


And the cog should be extremely low as it is.

[onlyifihadachevy]

well we haven't done anything for a little but we are gonig to work on it this weekend hopefully, a roller.

[onlyifihadachevy]

well the fronts almost a roller, and back still needs work but a updated pic at pretty much ride.


And a little of the plan for the front.

[onlyifihadachevy]

well we restarted , we started taking everything off, so i could get more head room and better leg position. I will get pic later.

[onlyifihadachevy]

Still working on it slowly, we flexed it tonight and found we need to work on the shock clearance, so after it done more pics.

A bad one

[70 beast]

we need some daytime shot of this thing!!!

[onlyifihadachevy]

yup, we have been slacking. I will get some garage pics of it tomorrow as it sits. We still need to do a lot.

[onlyifihadachevy]

Well a lot has happened personally, so no progress. But today My dad and I worked on the black truck and will get some wheeling pics tomorrow.

[onlyifihadachevy]

Well went to hollister and the hubs gave us problems and the passenger rear tire blew a bead so didnt do much.

[onlyifihadachevy]

[onlyifihadachevy]

Well havent done much, my dad has the welder and he isn't living with us now. But things happen, but this weekend I plan to work on the roof and dash sections. And here is some pics of our fix for the frame being to wide, and the shocks hitting.

[dammitmitchell]

good to see you back at work dude!
hope your personal lifes panning out well!

[onlyifihadachevy]

Here is some more up to date pic of tape bars. and fully extended.

[onlyifihadachevy]

Here are some pics it was hard to get it up the drive way and back in.

[onlyifihadachevy]

O and one on level ground. 13in belly with 38.5s that are wore out and 70 roof.

[onlyifihadachevy]

Well i tried to get the hole saw off the notcher, wasnt strong enough, so no updates for this weekend. but i did cut to bars for the front.

[onlyifihadachevy]

Well haven't been working on the buggy, because of dirtbiking and being tired, but i have been slowly messing around with the burnt truck. I got the steering wheel and shaft thing in. And now i need to wire it and put in the radiator, so i can wheel that till i get time for the buggy. I might post some pics of the truck in a few days.