|
05-02-2013, 02:07 PM
|
#26 |
|
Registered User
Join Date: Nov 2010
Location: Rustville USA or southeast Ia
Posts: 654
|
Re: 78 K10 Build "Hank"
Where did you buy your patch panel for the rear lower bedside from it looks like yours fits. I bought mine from classic parts and it doesn't fit right inside the fender well. The lip for the wheel arch sticks out farther the original lip i have a few pictures to show what i mean.
__________________
Rust is better than rice. 
|
|
|
|
05-02-2013, 08:01 PM
|
#27 |
|
Registered User
Join Date: Sep 2011
Location: Lake stevens
Posts: 48
|
Re: 78 K10 Build "Hank"
I got mine from my parts truck. I cut a few more inches than I needed and trimmed it to fit. You just need to trim yours around that lip.
Posted via Mobile Device
__________________
"Hank" 78 k10 6" lift 33's, good wrench 350 sm465 np205 |
|
|
|
|
05-02-2013, 08:14 PM
|
#28 |
|
Registered User
Join Date: Nov 2010
Location: Rustville USA or southeast Ia
Posts: 654
|
Re: 78 K10 Build "Hank"
why can't some where just sell me a patch that fits... grr i can't just trim it i would either have to completely grind the edge or cut it off trim it and re weld that bit on.
__________________
Rust is better than rice.
|
|
|
|
|
05-02-2013, 08:21 PM
|
#29 |
|
Registered User
Join Date: Sep 2011
Location: Lake stevens
Posts: 48
|
Re: 78 K10 Build "Hank"
You can trim it. Just take measurements from the other side if you are worried. Just draw a line and cut it flush with the existing lip. Or cut the flat part short and blend the area where it starts to curve. You are cutting the old stuff out right?
Posted via Mobile Device
__________________
"Hank" 78 k10 6" lift 33's, good wrench 350 sm465 np205 |
|
|
|
|
05-03-2013, 02:01 PM
|
#30 |
|
Registered User
Join Date: Nov 2010
Location: Rustville USA or southeast Ia
Posts: 654
|
Re: 78 K10 Build "Hank"
cutting the old stuff out? if you mean rust then yes the bad has already been cut out. I just don't think i could get the curve right.. I wish i could find a company that makes a better patch
__________________
Rust is better than rice.
|
|
|
|
|
05-03-2013, 05:49 PM
|
#31 |
|
Registered User
Join Date: Sep 2011
Location: Lake stevens
Posts: 48
|
Re: 78 K10 Build "Hank"
I wish you were local so I could help you out.
Posted via Mobile Device
__________________
"Hank" 78 k10 6" lift 33's, good wrench 350 sm465 np205 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
