drive shaft alignment problems

[captain69]

What do you think less than a finger maybe 1/4

[captain69]

Ok quick fix operation must take the wife out to dinner in the truck you have spent to much on.

[davepl]

If this was a small block truck and now carries a big block, did you get the correct frame pedestals? I don't know the precise difference, but if the small block ones are taller, which I suspect they might be, then you're never going to get it high enough in the back without it hitting.

Also, how did you 'lower' this truck? With new spindles or has the body's position relative to the frame changed?

[captain69]

Bib block motor mounts but now I think I might have hurt the motor. I cant win with this truck I swear. From jacking up the trans and motor my throttle linkage bent to wide open throttle and I didnt have a revlimiter chip in. Went to pull it of the ramps reved to the moon before I could shut it back down I have push button start and switches. Now gota pull the valve cover off got a tick in the back driver side hopefully a rocker is loose or just a bent pushrod and not a valve.

[captain69]

Lower 5 inches in rear eibach springs front eibach 2 inch springs 2 1/2 drop spindles