|
09-12-2019, 09:07 AM | #1 |
Senior Member
Join Date: Jun 2017
Location: burlington north carolina
Posts: 1,030
|
Re: Cab and Bed cuts
|
09-11-2019, 09:40 PM | #2 |
Account Suspended
Join Date: Jul 2016
Location: Tacoma, WA
Posts: 6,873
|
Re: Cab and Bed cuts
Are you trying to use the 2 edges with bolt holes? Also is 12” going to run into a crossmember?
|
09-21-2019, 09:07 PM | #3 |
Registered User
Join Date: Oct 2009
Location: Fort Lauderdale, FL
Posts: 70
|
Re: Cab and Bed cuts
I’m looking for the outer top driver side windshield corner
__________________
1970 c-10 406 or 383/400 4.5/6 work in progress 1985 c-10 454/400 4.5/6 work in progress 1955 bel-air 383/700r4 2001 dodge cummins 600hp daily driver |
09-26-2019, 10:22 AM | #4 |
Senior Member
Join Date: Dec 1999
Location: TX
Posts: 1,575
|
Re: Cab and Bed cuts
Hi Randy...
Do you have this piece of the floor that is good. This is a high hump 1968...but I am not going to use the 1968 gas pedal so I'm pretty sure it can be any year...High or low hump. |
09-26-2019, 12:13 PM | #5 |
Senior Member
Join Date: Dec 1999
Location: TX
Posts: 1,575
|
Re: Cab and Bed cuts
Cancel that request randy....I'm going to go get the patch panel at Summit....It's only $30
|
09-26-2019, 12:22 PM | #6 | |
Account Suspended
Join Date: Jul 2016
Location: Tacoma, WA
Posts: 6,873
|
Re: Cab and Bed cuts
Quote:
Im pretty sure i have that piece, haven't had a chance to look yet. |
|
09-26-2019, 01:18 PM | #7 |
Account Suspended
Join Date: Jul 2016
Location: Tacoma, WA
Posts: 6,873
|
Re: Cab and Bed cuts
Picture, $50 shipped for a size that will fit in med flat rate box...11×11 or so?
|
Bookmarks |
|
|