C4 Corvette Subframe DOM tubing - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Oklahoma_k5 · 09-19-2012, 02:22 PM

I've been hiding in the shop working on a way to put 84 Corvette suspension in my 52 Chevy. I found a couple of ways to do it but I didn't want to spend $800 on square tubing. Especially when I have a tubing bender, press brake and metal laying around.

I'm trying to post up a few pictures.

Made from 3/16 plate, some 1 3/4 .120 wall DOM, and the bent pieces are 1 3/4 .090 wall DOM.

Have a few details I'm still working on. I still haven't found out if the lower A Arm mounts are level front to back or if the whole assembly should be tilted back in the truck frame.

Any thoughts?

09-19-2012, 02:22 PM	#1
Oklahoma_k5 Registered User Join Date: May 2011 Location: Muskogee, OK Posts: 49	C4 Corvette Subframe DOM tubing I've been hiding in the shop working on a way to put 84 Corvette suspension in my 52 Chevy. I found a couple of ways to do it but I didn't want to spend $800 on square tubing. Especially when I have a tubing bender, press brake and metal laying around. I'm trying to post up a few pictures. Made from 3/16 plate, some 1 3/4 .120 wall DOM, and the bent pieces are 1 3/4 .090 wall DOM. Have a few details I'm still working on. I still haven't found out if the lower A Arm mounts are level front to back or if the whole assembly should be tilted back in the truck frame. Any thoughts?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.