Suburban and panel finds

[SoCoC10]

This one has been posted here before but it's back up for sale again. Rare one...
https://cosprings.craigslist.org/cto/6545372214.html

[Dieselwrencher]

Yeah, that could make a nice truck. I told one of my friends about it but he just picked up a 68 K10 burb.

[mrtoni]

Pretty decent
https://sfbay.craigslist.org/eby/cto...559253749.html

[oski6754]

52napco, are those 33 x 10.50 BFG running on 15x6.5 original steelies?

[Killer Bee]

very clean looking stock body sleeper up in SLO with bite to back up its bark

1971 Chevrolet Suburban - $20000

from the looks of things, likely very well done.. like to see the interior and engine bay

This one is a heart breaker, I'm totally upside down, spent over $40,000 not including the cost of the vehicle on custom built 496cc big block which produces 550 hp, backed by rock land transfer case to a custom 4L80E (electronic with overdrive) transmission. Rare 3 door 4x4. Must go.

[Killer Bee]

decent looking 4wd project starter in LA

1971 Chevrolet Suburban K20 3/4 Ton - $4800

Price is negotiable/ OBO/ make an offer

It, runs, drives, is my daily driver. Four wheel drive and front manual lockers work.

Within the last 6 months I have replaced:
Front and Rear Brakes
Front and Rear Shocks
5 Toyo M55 tires (mismatched rim on spare)
Rear wheel bearings and races


Needs:
Upper ball joint on passenger side (have, not installed)
Tie rod ends (have, not installed)
Heater re-installed
Rust repair in Passenger and Driver's rear quarter panels
Has exhaust leak on Driver's side exhaust manifold

Leaks a bit of oil, trans and power steering fluid. Not much, maybe a quart every 6 months.

[Killer Bee]

BBC two wheeler in Gardena

1971 Chevy Suburban - $4500 (Gardena)

1971 Chevy Suburban 400 Big Block, Automatic Transmission, 3/4 Ton, Clamshell 3 Door, Runs, needs work, $4500 OBO....No Trades and No Help needed to sell. If interested please call Javier at (310)920-1225.

[Killer Bee]

CHEVY SUBURBAN CHEYENNE - $25000 (Northern CA)

71 SUBURBAN CHEYENNE
NUMBERS MATCHING
BARN DOORS
402 BIG BLOCK
TH400 TRANSMISSION
12 BOLT POSI REAR END, 3:73 GEARS
POWER DISK BRAKES
TILT STEERING
NEW PAINT
NEW DASH PAD
NEW SEAT COVERS
NEW FRONT CARPET
NEW REAR SEAT BELTS
NEW GLOVE BOX LINER
NEW INTERIOR HEATER & DEFROST HOSES
NEW HEATER CORE
NEW MAHOGANY STEERING WHEEL
NEW BELTS & HOSES
NEW ALUMINUM RADIATOR
NEW 100 AMP ALTERNATOR
NEW AIR GAP EDELBROCK HIGH RISE MANIFOLD
NEW EDELBROCK CARBURATOR
NEW CERAMIC COATED HEADDERS
NEW MAGNAFLOW MUFFLERS, 2 ½ EXHAUST SYSTEM
NEW GASTANK AND SENDING UNIT
NEW KYB SHOCKS
NEW REAREND SWAYBAR
NEW TIRES WITH CHEVY RALLY RIMS
NEW RADIATOR SHROWD
NEW TRAILER HITCH
NEW WINDSHIELD AND RUBBER
NEW DOOR RUBBER (ALL)
POWDER COATED: RADIATOR SUPPORT, INNER FENDER WELS, MASTER CYLINDER & BOOSTER, HOOD HINGES, UPPER RADIATOR BRACKET
ELECTRONIC IGNITION - PETRONIX
E3 SPARK PLUGS
TINTED WINDOWS
K & N AIR CLEANER, OPEN ELEMENT
CHROME VALVE COVERS
CAR COVER

5000 miles since rebuilt- ALWAYS GARAGED

INQUIRIES CALL: show contact info , HOME PHONE

[Killer Bee]

1972 chevy c10 suburban 3 door MUST SEE - $10500 (Ontario)

1972 Chevy C10 Suburban for sale this was an older restore all the upholstery has been done door panels tinted windows has a rebuilt 454 the previous owner called it a 468 motor believe it was bored 30 over runs and drives excellent very smooth effortless ride unbelievable how smooth the vehicle drives motor has less than 500 miles on it automatic transmission original hubcaps clean title current tags call brake work perfect has lots of new parts it does have an issue with the outer rockers on both sides they have rust no internal rest just outer rockers have rust less than $500 to replace these parts on the body overall very nice truck has all the seats rare 3-door Suburban hot rod asking $10,500 or possible trade?

[HO455]

Originally Posted by Killer Bee

CHEVY SUBURBAN CHEYENNE - $25000 (Northern CA)

That shore is a nice headliner in that there Burban.

[1968k20]

Originally Posted by Killer Bee

decent looking 4wd project starter in LA

1971 Chevrolet Suburban K20 3/4 Ton - $4800

Heater delete!

[HO455]

CRB/10 72 project $2500

https://seattle.craigslist.org/see/c...567805150.html

CRB - Crusty, Rusty & Bondo!

1972 Suburban 350/350 combo
'69 / '70 Grill
2 Bench seats.
Aftermarket steering wheel.
Original A/C including Rear!
Ugly 18" wheels (maybe ok looking on something else, just not on this classic)
Rockers are rusty. Right rear taillight area is dented and filled with Bondo.
Drivers rocker (what's left of it) is filled with Bondo. Right rear fender has a thick Bondo patch.
Seems like it runs good. (My son bought it with the supposed intention of restoring it, but hasn't done anything to it other than dropping in a brand new battery). Needs total restoration, or drive it as is if that's your style.

Located in Eastern Washington, north of Spokane.
No low-ball offers, but cash does talk.

[HO455]

1970 project $2500

https://portland.craigslist.org/clc/...571403967.html

1970 Chevy suburban ran and drove but the motor and transmission is out now All the parts everything goes with the suburban all patch panels Rust in the usual spots but not too bad. 350 Small block Chevy and a th350 transmission.

[Killer Bee]

1972 Chevrolet Carryall Suburban 4X4 CUMMINS DIESEL RE-POWER - $14999 (Torrey Pines)

Listing my old Suburban. This truck has a lot of soul and has had a lot of work put into it over the last few years. Been in the family since new, and has been cared for accordingly. It received a Cummins 12v re-power in 2014 using a intercooled 1992 Cummins VE pump 5.9L. I made sure to keep the swap clean and sanitary under the hood, with as little wiring as possible. The engine is backed by a 47RH out of 1995 Dodge, that received a heavy duty build by ATO Transmissions in Sacramento, CA-not cheap. NP205 transfer case that I just re sealed with all new bearings. 4" turbo back exhaust. Denny Stage 2 fuel pin, as well as a 3200 RPM governor spring, HX35/40 hybrid with a 10 blade T wheel (sounds really good) and all the gauges, otherwise stock engine-doesnt even burn oil and fires up instantly. Aluminum radiator with dual fans, B&M trans cooler and power steering cooler. Manual cable fuel shut off for the zombie apocalypse. I used Autoworld's crossmember and engine mounts. It has a Dana 60 up front which has the 35 spline outers, with Yukon manual locking hubs, rebuilt with all new bearings and seals. Dana 70HD in the rear. Both with locking diffs, the rear being an Eaton E locker with a fresh gear set, carrier and pinion bearings, all new rear brakes, ORD hub seals that were a serious upgrade, and a Spartan locker up front. Pretty much an un breakable combo at this trucks weight/power. 4" leaf spring lift, with a shackle flip by Off Road Designs in the rear with 2" lift leaf springs, works out to roughly 5.5-6" of lift all said and done. ORD crossover steering, with a PSC steering gear box, as well as PSC hi volume power steering pump. The big pump helps keep up with the Hydro boost brakes as well. I installed a ORD steering brace to keep the steering box bolted solidly to the frame-these old trucks have a habit of cracking. ORD heavy duty leaf shackles up front, with greaseable shackle bolts all the way around. It has humvee wheels with internal bead locks, on BFG Baja's. Brand new matching spare on a humvee wheel. It has a 50 gal fuel tank. Original seats recovered in leather (wear and tear), with the third row facing aft, 9 seat belts to fit 9-11 pretty comfortably. The interior is actually quite nice, the paint on the dash and doors is the best I've seen, usually these old trucks are pretty nasty in that regard. Also has a leak free sun roof with a two position setting. The list goes on and on and quite honestly I cant think of much else you could do to it, pretty much bullet proof. If you know these trucks or are familiar with an older rig that's been converted, you know they're a lot of work, so keep that in mind. I was a mechanic by trade so keeping it going was pretty straight forward. It has gotten me to 5 duty stations, all on opposite corners of the country and never let me down. The body is RUSTY!! So you better be good at body work or have some other plan, these things are prone to it, the manufacture didn't seal the inside of the body panels. There's around 40K on the Cummins conversion parts. It gets great mileage and is pretty fun to drive, of course it turns heads and is a conversation everywhere you go. Please email me your # and we can chat about all the things I left out. I have a library of pictures from the conversion as well as all the mods it received along the way. I've debated on the price for a while, I'm going to start high because..craigslist..make an offer. I can't stress enough that I do not need to sell this thing, so no bs please.

[Travisarmenta]

possible Highlander burb?

https://redding.craigslist.org/cto/d...576007297.html

[Killer Bee]

Originally Posted by Travisarmenta

possible Highlander burb?

https://redding.craigslist.org/cto/d...576007297.html

like to see the SPID on that one.. if someone investigates it, please share a photo with us, thanks!

[Hart_Rod]

Originally Posted by Killer Bee

1972 Chevrolet Carryall Suburban 4X4 CUMMINS DIESEL RE-POWER - $14999 (Torrey Pines)

I'm pretty sure I know the owner of this one, I believe he's a boardmember.

[BGarza13x]

Guys, the triple axle is for sale again. Or is it still? I don't remember it being this cheap.

In 2012 it was 5500, now its 2700. Can't someone help take this thing out of its misery?

https://www.facebook.com/marketplace...49748315804587

I will admit, I would consider using it for parts and dismantling the damn thing. I want new fenders and bumpers and I've always liked the GMC grille more.

[Perpendicular]

Originally Posted by BGarza13x

Guys, the triple axle is for sale again. Or is it still? I don't remember it being this cheap.

In 2012 it was 5500, now its 2700. Can't someone help take this thing out of its misery?

https://www.facebook.com/marketplace...49748315804587

I will admit, I would consider using it for parts and dismantling the damn thing. I want new fenders and bumpers and I've always liked the GMC grille more.

I want that truck - I need that truck. I just have no way of getting it here. Anyone have an idea? Geeze, I have to have it...

[Bigdav160]

I wonder how hard it would be to separate the two and make a Suburban (again) and matching trailer?

[Dieselwrencher]

https://desmoines.craigslist.org/cto...554357305.html

[Advanced Design]

Originally Posted by Dieselwrencher

https://desmoines.craigslist.org/cto...554357305.html

71 suburban, LBZ Duramax and Allison, EFI live dsp5 240hp tune, air dog lift pump, Dakota Digital gauges, cruise, old air products ac...
facebook.com/farmfab

[HO455]

71 Burban project. $2700. I'm not sure why but I am unable to load pictures at present.

https://salem.craigslist.org/cto/d/1...589115079.html

Selling my 1971 suburban, No engine, No transmission, very clean and straight for it's age, no broken glass, it will come with an extra set of fenders and a set of door shells. And also it will come with a half of cab if your interested in building a crew cab, comes with lots of parts, I used to collect these trucks about 15yrs ago so I've got lots of parts that will come with the burb. I have the grill for it in the back.

[Airjammer88]

Hey guys I’m looking for a 69 to 72 k20
Suburban if any of the board members have one they want to let go pm me. I check craigs list daily so I’ve seen all those already. Thanks ��

[Airjammer88]

https://houston.craigslist.org/cto/d...600084602.html