|
07-19-2017, 08:17 PM | #1 |
Registered User
Join Date: Aug 2010
Location: North West Ohio
Posts: 18
|
Re: Rusty 68 K20 Burb
|
07-20-2017, 07:00 PM | #2 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
Here is where I am measuring from. If that measurement is on the $ then I am close.
|
07-20-2017, 07:05 PM | #3 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
So the gas tank might be able to move slightly forward. The front body mount has room to go forward just enough. I got to lift off the body again to remove the stock 78 K20 Driver rear shock mount that is mounted to the top of my frame. It is in the way of a crossbar.
|
07-20-2017, 07:28 PM | #4 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
Fuel filler is on the opposite side too. Not sure what I am going to do about that. Might just hack up a 81-91 burb filler door setup.
|
07-20-2017, 07:11 PM | #5 |
Registered User
Join Date: Aug 2010
Location: North West Ohio
Posts: 18
|
Re: Rusty 68 K20 Burb
|
07-20-2017, 07:30 PM | #6 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
|
07-20-2017, 08:09 PM | #7 |
Registered User
Join Date: Aug 2010
Location: North West Ohio
Posts: 18
|
Re: Rusty 68 K20 Burb
I measured from the top of firewall by the seal
|
07-20-2017, 08:30 PM | #8 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
I almost had to do this.
|
07-21-2017, 01:39 AM | #9 |
Registered User
Join Date: Jul 2011
Location: Aptos
Posts: 363
|
Re: Rusty 68 K20 Burb
So the neighbor was out of town and let me get a few more measurements. Looks like I am 5" off the mark, and my core support will have to come up too. This puts the front body mount in the way of the upper shackle. I might have to swap in the 52" springs and move the eye hole back sooner than later.
|
Bookmarks |
|
|