VA Cheyenne super and Sierra grande emblems, & glovebox door

[lolife99]

Originally Posted by VA72C10

I have one of the glovebox and one of the dash left but the dash one is 67-68 with the choke hole...

Thanks anyway.
I need a 69-72 bezel style.

[VA72C10]

ttt

[VA72C10]

ttt

[landsurvey1]

I would be interested in buying a restored Cheyenne Super glove box door. I have a 72 K-20.

[VA72C10]

Originally Posted by landsurvey1

I would be interested in buying a restored Cheyenne Super glove box door. I have a 72 K-20.

do you want the panel overlay shown in the thread I did (matches stock color grain better) or I can send one of these to CSM to have it restored.

[VA72C10]

ttt

[VA72C10]

ttt

[VA72C10]

ttt

[skrenly]

I will give you $125. for the sierra grande bed emblems, and wood grain glove box door with sierra grande emblem.

[VA72C10]

Originally Posted by skrenly

I will give you $125. for the sierra grande bed emblems, and wood grain glove box door with sierra grande emblem.

I'd do 175 shipped to you. That's 50 less than I was asking so meeting you half way

[HDBOB]

What is the best you could ship just the Sierra grande emblems ? Do they have the studs ?
Thanks !!

[VA72C10]

Originally Posted by HDBOB

What is the best you could ship just the Sierra grande emblems ? Do they have the studs ?
Thanks !!

85 shipped. They have outer studs on both ends...i think there were originally a third stud in the middle??? If so, it's missing on both.

[72blazr]

I need to redo the woodgrain on my glove box door. where do you get the woodgrain aplique?? Would you sell? Also, how do you get the cheyenne super emblem off.

[VA72C10]

Originally Posted by 72blazr

I need to redo the woodgrain on my glove box door. where do you get the woodgrain aplique?? Would you sell? Also, how do you get the cheyenne super emblem off.

The woodgrain that matches is NOS vinyl ( I have a partial roll but haven't decided to sell or not yet), the one pictured earlier that was repop I got as part of a parts deal I purchased that had tons of repops pieces, patch panels, mcgaughy's stuff, and some used parts....
The aftermarket appliques are thicker than the NOS vinyl and match factory door panel coloring better. The NOS vinyl was originally intended for the lower woodgrain moldings. I plan to use this on my truck so that all of the woodgrain on the truck matches 100%

Several vendors sell glovebox overlays....I prefer to get the full size one and cut to fit vs getting one made for a super which is cut smaller...

For removing the emblem I use a painter's tool...it's like a putty knife but sturdier...I slide it under all the way around first then start working towards the center and prying up...being careful to keep it flat so it doesn't gouge the metal....

Some come up easier than others...some seem like they won't come off at all without a huge amount of effort.

[HDBOB]

Going to pass, for 85. they look real good though. Thanks,

[j carter]

do you still have the sierra grande glove box door

[VA72C10]

Yes
Posted via Mobile Device

[j carter]

how much with shipping? and also is it the same one on the pic on page one?

[VA72C10]

Same as in pics. Add 15 for shipping

[j carter]

ok i just sent a pm