GA Suburban rear half part out/cuts

[Madkidd007]

TtT

[ajgriffin]

I didn't see it, but curious if you have the driver's wheel well? I need the front flange off it so I can patch it onto my passenger rear wheel well where the spare would normally go.

[Madkidd007]

Originally Posted by ajgriffin

I didn't see it, but curious if you have the driver's wheel well? I need the front flange off it so I can patch it onto my passenger rear wheel well where the spare would normally go.

I just went outside and looked, it is eat up. Unless you can make the flange that goes between the tubs work I don’t have anything to help

[ajgriffin]

Originally Posted by Madkidd007

I just went outside and looked, it is eat up. Unless you can make the flange that goes between the tubs work I don’t have anything to help

I'm guessing you're talking about the section of the tub that runs front to back? I need a piece that will go here. Its about 2" tall and 11" wide. What do you think?

[Madkidd007]

Originally Posted by ajgriffin

I'm guessing you're talking about the section of the tub that runs front to back? I need a piece that will go here. Its about 2" tall and 11" wide. What do you think?

Attachment 1949760

You are correct on the front to back piece. If you compare to your tub in the picture and looks like the front to back section will work. I’ll remove the wood and check the condition on the tub I have

[Madkidd007]

It’s an old thread with old parts, but still have them stashed behind the house.

[Madkidd007]

For mrweld. What’s left

[mrweld]

Originally Posted by Madkidd007

For mrweld. What’s left

those will work fine, just need the sheet metal if you need the rest

[Madkidd007]

Originally Posted by mrweld

those will work fine, just need the sheet metal if you need the rest

So if I finished the vertical cut to the top so they are a lot smaller to ship would that work? Say $20 a side plus $20 for shipping & PayPal’s fee, $60 all in to your door? If so just use my paypal below and I’ll get them cut when I wake up this afternoon.

[mrweld]

Originally Posted by Madkidd007

So if I finished the vertical cut to the top so they are a lot smaller to ship would that work? Say $20 a side plus $20 for shipping & PayPal’s fee, $60 all in to your door? If so just use my paypal below and I’ll get them cut when I wake up this afternoon.

I have a big rust hole in top, I will need them as pictured. I think that will cover it

[Madkidd007]

Originally Posted by mrweld

I have a big rust hole in top, I will need them as pictured. I think that will cover it

I’ll do some weights and measuring later then

[mrweld]

Originally Posted by Madkidd007

I’ll do some weights and measuring later then

ok thanks

[Madkidd007]

These are gone. Few pieces left if anyone could use something make an offer