My 58 Brookwood

[skymangs]

All mocked up after pulling the column and brakes 5 times to ensure everything fit

[skymangs]

Here’s the lower column bracket we made
Here’s an "in progress pic of the firewall

[skymangs]

Firewall is all finished and we begin final install on the brakes and column tomorrow

[skymangs]

These are the handmade motor Mount Adapters
The motor Mounts and Adapters required Modification

[skymangs]

We Built the motor mounts and test fit the engine today

[skymangs]

Today we put on the collector’s and welded the O2 bungs
We also created a firewall pass through for the Wiring harness.

[skymangs]

The new alternator came in
The new O2's came in
And we finally pulled that lifting plate off and put the Valley cover back on

[skymangs]

Here is that 600hp LS3 nestled in the engine bay!
Here’s a view From the bottom of That 4L80E and how well it Fits.

[gigamanx]

Looking awesome. I like those valve covers on the LS3. A bit of old school flare with the fins. Where did you find them? Is the harness a holley terminator?

[skymangs]

Nope, bought it one eBay. $450

[skymangs]

we put 2 3/8 nipples in the bottom for the brake booster and the PCV

[skymangs]

Here’s the overview of how the engine looks in the bay
so we cut the tunnel 7” wide to facilitate the installation of our 12” Lokar tail shaft mounted shifter

[skymangs]

We got the right MAP sensor in today and mounted it
I think it looks clean on the back of the intake
Here’s that LS3 in the engine bay. Just can’t get enough of that sick looking MF'er!

[skymangs]

We put the 3/8 hoses on the intake
Routed the steam tubes
This is the engine with all the Wiring ran and plugged in

[Ol Blue K20]

Looking good!

[skymangs]

Thank you

Today we modified the Transmission crossmember to slide 8” back for our 4L80E

[Ol Blue K20]

It's coming along nicely. Keep plugging away!

[skymangs]

We are only able to work on it about an hour a day.