SC Cabs For Patches and A 67 Fender For Patches

[C5Phil]

Originally Posted by C5Phil

. By chance would you still have/consider selling- a cut out patch from your cab -I need the piece that incorporates the gas filler neck behind the drivers door- if you could cut me a patch panel that runs from the trim line two inches above filler to about 10-12 inches below the filler (I don't need the door jamb- just to the edge of the jamb and to the back of the cab)) I'd be very appreciative-- I hope I'm describing it correctly but my cab - under Po- took a hit right under gas filler neck- PO bondo-ed the area and I'd like to repair it properly-- let me know- - Thanks- Phil H.

Same piece as mcbassin displayed in his post...

[wancosc356]

Originally Posted by mcbassin

Michael,
I don't need that portion I marked. As I picked up a different cab. What is the condition of the drip rails? I would be interested in some long pieces for patches or the complete drip rail, tell me what you got. thanks

The drip rails are good in various spots. Where exactly do you need?

Originally Posted by loosecannonzs

I need this section from both sides of the cab if they are rust hole free and still available. Shipped to 33021

Thanks, Ron

Both of those sections of the cab have been cut in the door jamb. Sorry.

Originally Posted by C5Phil

. By chance would you still have/consider selling- a cut out patch from your cab -I need the piece that incorporates the gas filler neck behind the drivers door- if you could cut me a patch panel that runs from the trim line two inches above filler to about 10-12 inches below the filler (I don't need the door jamb- just to the edge of the jamb and to the back of the cab)) I'd be very appreciative-- I hope I'm describing it correctly but my cab - under Po- took a hit right under gas filler neck- PO bondo-ed the area and I'd like to repair it properly-- let me know- - Thanks- Phil H.

That piece you need, looks like it has a dent on the back side. I'll check it out myself and get back to you.

[C5Phil]

here's what I need- let me know-- looking for a good no rust/bondo undamaged piece- but my standards can be lowered...

[mcbassin]

Originally Posted by wancosc356

The drip rails are good in various spots. Where exactly do you need?

I would like to have both the sections over the doors and some patch pieces from the front. How much shipped to 74851 OK?

[loosecannonzs]

Ok thanks.

[tanman722001]

Hi Michael,Do you still have any cabs left?Of have you hauled them all off?Thanks Tony