What did you do to your truck today!

[yonah]

Took out the clutch in my '67 C10 and found a 9" disk with a 10" plate. Doh

[truckindude]

well i cleaned the bed out scrubbed some mold off the paint and drove it... wish it was wrmer i need to put plugs and wires in it too.

[mr48chev]

the temp was sitting at 06 Degrees F outside this morning I went out and looked at it and came back in the house. It is supposed to be above freezing tomorrow and I'll pull the starter and rebuild it then.

[todd99]

Painted my new motor.

[Dano69c10]

Pushed my '70 from it's 5 year parking spot behind my house and in front of my garage, spent the day chasing down parts for my cobbled up exhaust system, installed headers, exhaust and mufflers. It was 9 pm when I finally finished. Tomorrow I hope it starts, cause I want to drive it to the Legends get-together,...

[project 67 sub]

fixed the fuel leak by replacing the fuel hose with a metal fuel line, alsofound out that i need to replace the power steering belt, and might as well change the alternator belt while i am at it. also chaged the fuel filter.

[ETsC10]

Drove it, parked it, worried about the frozen snow on the toneau.
Guess I'd better do that.

hehe...don't fuss with the bugger much (not when it's cold!!!!)

[67Slider]

Scored some great parts from otsenre. What a great guy! While I was talking with him met another forum member 454Stepside. What a great bunch of guys we have on this forum. I scored a clean 68 grill w/ stainless loops and light buckets, front bumper with brackets, and some small parts fro 180.00 from otsenre. Great deal I think. Went down the road a few miles and scored a brand new GM(not repop), rear sport bumper for $55. Then I came home and cleaned all the greasy fingerprints off her.

I think I'll head to the package store for some adult beverages.

[glider_6969]

This weekend I put in my brake booster, finished with the dash panel, hooked up the the new gauges, water, oil and volt meter.

[Sicklajoie]

Put my new tire and steel wheel combo on today.

[67swb72klb]

got a deal worked out on that gas guzzling big block in 67 swb fired it up didnt quite get through all that snow we got through last week about 10 feet short hooked up to 72 k10 put a tug on it got (67) back in the garage @ my place gona drain some fluid & get it out tomorow so the guy can pick it up that thing wouldnt pass a gas station

[doaner70]

Drove my 70 swb stepper about 150 miles today. Put new sun visor in. Got a new insterment panel out of a 2 and a half ton 70 grain truck wich has tach in it and thats where i got the visors from. Also cut the back bumper off today becouse someone welded a 80's bumper to the frame. Looks 10 times better now. Also installed a cd player in my truck to day. It was a good day.

[dmack91]

Fuel sending unit, spark plugs, and found a new grinding noise under the hood. I think it is water pump bearings.

[shawno72]

Insalled my license plate light assembly.

[67swb72klb]

took out the bbc loaded it up for the new owner & told him now he just needs to buy a gas station

[bollybib]

Fabbed up some steel lines and rubber hoses and reconnected the fuel lines (with a filter now, it had none before) and vacuum advance line in the engine compartment. Installed a new air filter. Fiddled with the idle mixture and speed and drove it up and down the street a few times. No noticeable leaks or gas smell; this is always a good thing.

[67swb72klb]

Originally Posted by bollybib

Fabbed up some steel lines and rubber hoses and reconnected the fuel lines (with a filter now, it had none before) and vacuum advance line in the engine compartment. Installed a new air filter. Fiddled with the idle mixture and speed and drove it up and down the street a few times. No noticeable leaks or gas smell; this is always a good thing.

i see that glass gas filter imo i would loose that thing they are not good had bad exp with em and heard about many others that have also !!

[bollybib]

Originally Posted by 67swb72klb

i see that glass gas filter imo i would loose that thing they are not good had bad exp with em and heard about many others that have also !!

Ok thanks I'll keep an eye on it.

[longblue72]

finished taking off the front clip!

[dmack91]

Got the antennae hooked up. Original AM works.

[Jeffs70]

finished up some fiberglass work on my center console and placed it in the truck for a test run. fit great so I began doing some more work on the dash.

[nick martorano]

Well Sunday morning I installed my new front suspension. I installed new upper and lower control arms, air bags and new 2" dropped spindles all from CPP. I also got the rear end re-installed with new trailing arms and drilled and slotted rotors and new posi unit etc. Also got my new wheels from Race Line with new BFG KDA's. I will post some pictures in the next days or so. Hoping to get the new LS3 installed this next weekend!

Pictures are posted in my album

[ItsRandy]

Cleaned and painted the emergency brake pedal assembly and the flat plate that mounts with it under the dash.

[Cambons]

put the fuel tank back in and cleaned the hoses should have it started agian since the 7 years its been sitting

[flashed]

I drove it to the body shop thats going to do my rust repair to get my parts list in order and bought a perfect original Fleetside tailgate to go on it when its time. Now I have a spare if something happens later on down the road. Looks like my truck will be rust free very soon.