HEI Distributor question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Gianyveedub · 10-14-2011, 04:05 AM

Hey all, I have not been on the forum for a while because the thrust bearing in my 230 went bad. I bought a 235 from a guy for 200 dollars. This engine was not easy to fit into my truck. I had to fabricate everything...the throttle linkage, z-rod support, engine mounts blah, blah, blah. Now my question is I have a 1975 Pontiac Firebird engine (6 cyl) with an HEI Distributor. I would like to take the Distributor and use it with the 235. I have read that some had to modify it and some say nothing was modified.

Has anyone had experience with it??
It looked like it was the same length.

10-14-2011, 04:05 AM	#1
Gianyveedub Registered User Join Date: Mar 2011 Location: Hollister, Ca Posts: 178	HEI Distributor question Hey all, I have not been on the forum for a while because the thrust bearing in my 230 went bad. I bought a 235 from a guy for 200 dollars. This engine was not easy to fit into my truck. I had to fabricate everything...the throttle linkage, z-rod support, engine mounts blah, blah, blah. Now my question is I have a 1975 Pontiac Firebird engine (6 cyl) with an HEI Distributor. I would like to take the Distributor and use it with the 235. I have read that some had to modify it and some say nothing was modified. Has anyone had experience with it?? It looked like it was the same length.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.