|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-27-2013, 10:14 PM
|
#1 |
|
Registered User
Join Date: Dec 2013
Location: Fort Worth, Texas
Posts: 27
|
1950 Chevy Truck S-10 frame Motor
I am putting my 1950 Chevy Truck onto a 1980's S-10 longbed truck. I picked up a chevy 350 out of a 1973 Camaro to put in the truck and wanted recommendations on a manual transmission. Does anyone have experience doing this swap or with a similar setup?
|
|
|
|
12-28-2013, 11:34 PM
|
#2 |
|
Registered User
Join Date: Oct 2011
Location: Hebron, IN
Posts: 194
|
Re: 1950 Chevy Truck S-10 frame Motor
I did one. Used a 350/350 combo though.
__________________
Mom, I think I may have broke something. My tires keep spinning and leaving black marks every where 
|
|
|
|
|
12-28-2013, 11:58 PM
|
#3 |
|
Registered User
Join Date: Dec 2013
Location: Fort Worth, Texas
Posts: 27
|
Re: 1950 Chevy Truck S-10 frame Motor
What did you do for motor mounts?
|
|
|
|
|
12-29-2013, 10:03 PM
|
#4 |
|
Registered User
Join Date: Sep 2011
Location: Golden Valley,MN
Posts: 639
|
Re: 1950 Chevy Truck S-10 frame Motor
I used a 327 with th350 for my swap. For motor mounts I used S10 mounts for the 4.3 6 cyl that was available for the S-10. Bolted right up to my 327. After fitting the motor/trans where I wanted it in engine compartment, I tack welded the mounts to the frame, lifted the motor out and finished the welding. Then reinstalled the motor/trans. Really not too difficult. I'm sure using a manual trans would be about the same.
__________________
My build http://67-72chevytrucks.com/vboard/s...d.php?t=495795 |
|
|
|
|
| Bookmarks |
| Tags |
| 1950 chevy truck, 350, manual transmission, sbc |
|
|
Hybrid Mode
