|
03-16-2013, 10:07 AM
|
#1 |
|
Registered User
Join Date: Aug 2012
Location: nantucket,ma
Posts: 230
|
not sitting right
i have a question,on my 72 c10 2wd i purchased the truck with drop spindles on it and i am not sure how low they are.after installing 3 inch drop coils i noticed the bump stop on the drivers side already bottomed out and the pass side about 1 inch away.is this normal to have little to no travel in the suspension? the truck is going on the frame machine to fix the front drivers frame horn that is down 1 inch do you guys think this will fix the problem? thanks for the help.i would post photos but have no clue how to.
|
|
|
|
03-16-2013, 10:30 AM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: not sitting right
yep that is what has happened for as long as i remember
did you measure b4 you started?? example is if you had 4" and subtract5 what you got left
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
03-16-2013, 12:06 PM
|
#3 |
|
Registered User
Join Date: Aug 2012
Location: nantucket,ma
Posts: 230
|
Re: not sitting right
no i never measured anything.is my truck too low? or is that how the bump stops are on a lowered c10.thanks for the help.
|
|
|
|
|
03-16-2013, 12:14 PM
|
#4 |
|
Registered User
Join Date: Dec 2010
Location: livingston co.mi
Posts: 2,457
|
Re: not sitting right
a lot of people seem to have problems with the 3" drop springs bottoming out
__________________
California 65 GTO---Texas 64 burb 283 ---Oklahoma 67 CST SWB BBW wood bed 327 2004r---New Mexico 72 k10 350 350 auto---Georga 72 short step project |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
